Do not exceed the maximum rated weight specified. Otherwise, serious injury or property damage may occur.
NOTE Please read the entire installation manual before you start installation and assembly. WARNING Do not begin to install your QualGear product until you have read and understood all the instructions and warnings contained in this installation manual. If you have any questions regarding the instructions, for US customers please contact QualGear customer support via email at support@qualgear.com. For all international customers, please contact your local distributor.
1a Mounting to a Wooden Stud Wall M-J Bubble Level For concrete or brick NOTE wall mounting, follow Step 1b. Stud Finder W-C W-A 1 2 Using an edge-to-edge stud finder, find the edges of the stud. Using a level, mark the centerline of the stud. A Wall Plate 5 Mount the wall plate (A) and tighten it with the provided 65mm (2.5") lag bolts (W-A) and D6 washers (W-C) using a socket wrench. ø 4.5mm (ø 3/16") NOTE Do NOT use power drill and do NOT over tighten the lag bolts.
1b Mounting to a Concrete or a Brick Wall NOTE C Do NOT use power drill and do NOT over tighten the lag bolts. Marking Template M-J Bubble Level A Wall Plate 1 W-C Hold the marking template (C) provided against the wall where you want to install your TV, mark six holes for drilling. W-A W-B 70mm (2.7") 3 ø 10mm (ø 3/8") Place concrete anchors (W-B) in each hole. Tap each anchor flush with the wall using a hammer.
M-A/ M-B 2a Installing to a Flat Back Panel of a TV B Adapter Bracket Flat Back Panel M-G 5.5mm e of the TV id Top Backs M-C/ M-D OR M-G 8.5mm Choose the appropriate screws and washers according to the type of your TV, and attach adapter brackets (B) to the back of the TV using a Phillips screwdriver. Top of the TV NOTE Make sure the adapter brackets are installed in the correct direction.
2b Installing to a Curved or Recessed Back Panel of a TV Choose the appropriate screws, washers, and spacers (if necessary) according to the type of your TV and attach adapter brackets (B) to the back of the TV using a Phillips screwdriver. 8.