Instruction Manual

SHINGLE SHARK
Model #1000
ROOFING
PRODUCTS
Product Specications
Shingle Shark
Model # 1000
The Qual-Craft Shingle Shark
TM
is
designed to allow for accurate and
repeatable cuts at any angle, as well
as lengthwise cuts for starter course
used along lower edge of the roof.
Versatile!
Cuts any angle.
Cuts any asphalt or berglass shingle.
Cuts starter row either U.S. or Metric.
Cuts material face up or face down,
and from either top or bottom edge
as desired.
Cuts ridge cap.
Cuts Lengthwise
Makes lengthwise cuts for starter row.
Two offset holes - one for metric, the
other for U.S. shingles.
Cuts Angles
Crosscut guide adjusts full 180° for
any angle. Cuts face up or face down
and from either the top or bottom
edge.
Can be set up by using a cleat to
prevent slippage. Can also be set up
by using a piece of 2x10 lumber and
footing the tool against it, or by using
a 6”x90° roof bracket.
Offset Guide Model # 1001
For 17” or 18” shingles.
Product Specications: Shingle Cutter
Model # 1000
Description: Shingle Shark
Unit Pack: 1
Weight per Pack: 52 Pounds
Cu. Ft. per Pack: 6.88 cu. ft.
Customer Support and Ordering Information
781-344-1000 • www.qualcraft.com