Chau, Hai (hchau) 09/06/06 Released - Internal Use Only 80-C6303-1.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 2 Friday, June 30, 2006 3:12 PM This manual is based on the production version of the QUALCOMM Globalstar GIK-1700 Globalstar Installation Kit. Software changes may have occurred after this printing. Released - Internal Use Only QUALCOMM reserves the right to make changes in technical and product specifications without prior notice.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page i Friday, June 30, 2006 3:12 PM Released - Internal Use Only Table of Contents Introduction .................................................................................1 Features .................................................................................... 1 Safety precautions when using the kit ................................... 1 Safety precautions when using the GSP-1700 Satellite Phone .......................................................
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page ii Friday, June 30, 2006 3:12 PM Privacy headset ............................................................................15 Privacy handset ...........................................................................15 Globalstar Data cable ..................................................................15 Released - Internal Use Only Operation ....................................................................................
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 1 Friday, June 30, 2006 3:12 PM Released - Internal Use Only Introduction Before using your Globalstar Installation Kit in a vehicle, please read this manual thoroughly and retain it for future reference. Professional installation is recommended. Features The Globalstar Installation Kit (GIK) allows your Globalstar GSP-1700 satellite phone to be used as a mobile phone in your vehicle.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 2 Friday, June 30, 2006 3:12 PM Introduction Caution Failure to follow these instructions and the GIK-1700 Installation Sheet may lead to serious personal injury and possible property damage. Secure the phone in your vehicle to prevent personal injury and damage to the phone in the event of an accident.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 3 Friday, June 30, 2006 3:12 PM Introduction standards previously set by both U.S. and international standards bodies: ■ ANSI/IEEE C95.1-1999 Standard1 ■ NCRP Report 86 (1986)2 ■ ICNIRP (1998)3 Released - Internal Use Only ■ IRPA (1991) Guidelines on Protection Against Non-ionizing Radiation4 The phone and this kit are designed to comply with established ANSI, FCC, and international safety standards for safe levels of human exposure to RF energy.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 4 Friday, June 30, 2006 3:12 PM Introduction Antenna care Use only the supplied or an approved replacement antenna. Unauthorized antennas, modifications, or attachments could damage the phone and may violate FCC regulations. Released - Internal Use Only Phone operation Hold the phone as you would any other telephone with the antenna pointed up and over your shoulder. Tip For your phone to operate most efficiently: ❑ Extend your antenna fully.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 5 Friday, June 30, 2006 3:12 PM Introduction ■ Pull off the road and park before making or answering a call if driving conditions require you to do so. Electronic devices Released - Internal Use Only Most modern electronic equipment is shielded from RF signals. However, certain electronic equipment may not be shielded against the RF signals from your wireless phone.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 6 Friday, June 30, 2006 3:12 PM Introduction your service provider (or call the customer service line to discuss alternatives). Optional for each phone manufacturer. Released - Internal Use Only Other medical devices If you use any other personal medical device, consult the manufacturer of your device to determine if it is adequately shielded from external RF energy. Your physician may be able to assist you in obtaining this information.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 7 Friday, June 30, 2006 3:12 PM Introduction Blasting areas To avoid interfering with blasting operations, turn your phone off when in a “blasting area” or in areas posted: “Turn off two-way radio”. Obey all signs and instructions. Released - Internal Use Only Potentially explosive atmospheres Turn your phone off when in any area with a potentially explosive atmosphere and obey all signs and instructions.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 8 Friday, June 30, 2006 3:12 PM Introduction Released - Internal Use Only or charged in a non-QUALCOMM charger, this energy can be released suddenly and result in potential injury. ■ Do not overheat the battery by leaving it on a heater or in the sun. ■ Do not dispose of the battery in a trash compactor or incinerator. ■ Use only charging accessories manufactured by QUALCOMM, and discontinue use of the battery if it becomes damaged.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 9 Friday, June 30, 2006 3:12 PM Released - Internal Use Only Components Check the components of the Globalstar Installation Kit listed below. If there is something missing, please contact the service provider where you purchased your kit.
Chau, Hai (hchau) 09/06/06 80-C6303-1.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 11 Friday, June 30, 2006 3:12 PM Components Component parts Released - Internal Use Only Globalstar Installation Kit The cradle (CV90-C6029-1) securely holds the Globalstar phone, interfaces to the vehicle’s power, and houses the electronic circuit for the kit. It provides and controls the supply voltages for the accessories and the charge current for the phone. Speaker The speaker (CV90-C6030-1) connects to the kit speaker jack.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 12 Friday, June 30, 2006 3:12 PM Released - Internal Use Only Components ■ The fused red lead connects to the positive terminal of the vehicle’s battery. ■ The black lead ground (GND) connects to a clean, unpainted metallic part of the vehicle. ■ The fused green lead (STEREO MUTE) is for car stereo mute. ■ The fused yellow lead (IGNS) is for ignition sense.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 13 Friday, June 30, 2006 3:12 PM Components Car Power Adapter Released - Internal Use Only The kit can alternatively be powered using the Car Power Adapter (CPA) (CV90-C6032-1). ■ Connect the CPA cable to the 4-pin connector on the back of the unit. ■ Plug the CPA into the vehicle’s car power port. Caution Refer to vehicle’s user manual regarding car power port operation.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 14 Friday, June 30, 2006 3:12 PM Components Released - Internal Use Only Caution DC voltage exists in the central conductor of the antenna cable. Be sure that the cable connector is installed inside the vehicle.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 15 Friday, June 30, 2006 3:12 PM Components Optional accessories (not included in kit) Privacy headset Released - Internal Use Only The privacy headset (GHS-1700) offers more privacy during a call and is connected directly to the phone. Privacy handset The privacy handset (GPH-1700) offers more privacy during a call and is connected directly to the phone.
Chau, Hai (hchau) 09/06/06 80-C6303-1.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 17 Friday, June 30, 2006 3:12 PM Operation Released - Internal Use Only Using the phone in a vehicle Attaching the phone to the Globalstar Installation Kit 1. Remove the kit connector cover label from the back of the phone. Remove This Sticker 2. Remove rubber plug from connector at bottom of phone. Rotate rubber plug toward antenna. 3. Insert the connector on the bottom of the cradle into the connector on the phone. 4.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 18 Friday, June 30, 2006 3:12 PM Operation 1. Insert plug into phone socket 2. Rotate phone into locked position. Released - Internal Use Only 2. 1. Phone Socket Plug Caution Do not pull the phone out of the cradle without first pressing the release button. If you do so, you could damage the phone and the cradle. Turning on the phone and kit When you turn on the vehicle’s ignition, the phone and the kit are turned on.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 19 Friday, June 30, 2006 3:12 PM Operation Released - Internal Use Only Accessory position ACC OFF START LOCK 358AB_1999Q Note If you turn off the vehicle’s ignition during a call, the kit remains on so you can continue talking. (The kit will remain on until the phone battery is fully charged. See Charging the phone battery, page 19.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 20 Friday, June 30, 2006 3:12 PM Operation Released - Internal Use Only If both the phone and the kit are powered down and the phone is placed in the kit, the phone will charge as long as: ■ the kit is wired to the vehicle battery, OR ■ the car power adapter cable has power (the light on the cable is lit). The phone will charge to full and then both the phone and the kit will power down.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 21 Friday, June 30, 2006 3:12 PM Operation vehicle is moving, use the hands-free microphone so that you can always concentrate on traffic conditions. Released - Internal Use Only If you turn off the vehicle’s ignition during a call, the call will not be interrupted. After you terminate the call, the phone will power off in 30 seconds. No subsequent calls can be made unless the ignition is turned on.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 22 Friday, June 30, 2006 3:12 PM Operation Connecting to a personal computer Connecting a Globalstar data cable (GDC-1700) from your computer or other device to the data port of the kit allows the phone to send and receive data. See Component parts, page 11. Released - Internal Use Only Note You cannot use the phone to talk while sending and receiving data. Privacy Headset Privacy headset operation Setting up the headset Before starting to drive: 1.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 23 Friday, June 30, 2006 3:12 PM Operation Using the headset To make a call with the headset: 1. Dial the desired number on the keypad of your phone. 2. Press . Released - Internal Use Only When you use the headset, the speaker and microphone are muted, and you can speak in privacy. To receive a call with the headset: ❑ When the phone rings, press any key except . See the phone user manual for information on the AnyKeyAnswer option.
Chau, Hai (hchau) 09/06/06 80-C6303-1.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 25 Friday, June 30, 2006 3:12 PM Troubleshooting Released - Internal Use Only If you have problems using the kit, look at these possible solutions before calling your service provider. Table 1. Error messages Message Recommendation Antenna not found Re-check phone connection to the cradle. Re-check cable connections between the kit, antenna cable, and antenna. MCU/Communication Error Re-check phone connection to the cradle.
Chau, Hai (hchau) 09/06/06 80-C6303-1.book Page 26 Friday, June 30, 2006 3:12 PM Troubleshooting Released - Internal Use Only Table 2. Other problems Problem Recommendation Speaker not working Verify speaker connection to cradle. Verify volume setting on phone is loud enough to hear speaker. Microphone is not working Verify microphone connection to cradle. Verify phone is not set to “mute” during a call.
Chau, Hai (hchau) 09/06/06 80-C6303-1.
Chau, Hai (hchau) 09/06/06 80-C6303-1.