Install Instructions

ManualsBrandsQuake Global ManualsElectronicsModule

SUBJECT

Instructions for installing the mobile terminal (HPRO) to the CAB

OUTLINE

To install the mobile terminal to the machine, follow the mobile terminal installation.

CONTENTS

1 Removing the rear cover

1-1 Remove the caps

1-2 Remove the bolts and screws

1-3 Remove the covers

2 Installing the mobile terminal

2-1 Routing of GPS harness and installation of bracket

2-2 Installation of mobile terminal

Safety Warnings and Hazards

Summary of content (8 pages)

PAGE 1
SUBJECT Instructions for installing the mobile terminal (HPRO) to the CAB OUTLINE To install the mobile terminal to the machine, follow the mobile terminal installation.
PAGE 2
1 Removing the rear cover 1-1 Remove the caps Remove the caps (5 locations). Remove the fuse cover 1-2 Remove the bolts and screws Remove the screws (3/9 locations) Remove the screws (3/9 locations) 1-3 Remove the covers Remove the screws (2/9 locations) Remove the bolts (2/3 locations). Remove the screws Remove the washers (2 locations). Remove the screws (1/9 locations) Remove the bolt (1/3 location).
PAGE 3
Remove in the following order: left and right covers (no specific order), upper cover and then, bottom cover. Work carefully with the lighter harness. Remove thethe coupling that is joined at the back to of the lighter left cover (dipolar).
PAGE 4
2 Installing the mobile terminal 2-1 Routing of GPS harness and installation of bracket The GPS cables are banded. Loosen the band. After installing the mobile terminal, band the excess cables in the same way as before. Loosen the band clips and pass the GPS cable through. Route. Then, retighten the band clips.
PAGE 5
2-2 Installation of mobile terminal Controller Screw, sems Harness, wire Connect each harness (3 locations).
PAGE 6
Safety Warnings and Hazards Read this section in its entirety before operating the Quake Global HPRO. Federal Communications Commission statement HPRO complies with Part 15 of the Federal Communications Commission (FCC) rules for a Class A device. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
PAGE 7
Garantie et responsabilité Un soin raisonnable a été apporté à la préparation des informations contenues dans ce document. Cependant, ce document peut contenir des omissions, des inexactitudes techniques ou des erreurs typographiques. Quake Global décline toute responsabilité en cas de perte due à l'utilisation de ce document. Les spécifications du produit sont sujettes à modification sans préavis.
PAGE 8
Le fonctionnement d'HPRO est limité à une utilisation en intérieur pour la bande de fréquence 5150 – 5250 MHz. Le PMN est HPRO. Avis d'exposition RF CET APPAREIL SATISFAIT AUX EXIGENCES GOUVERNEMENTALES EN MATIÈRE D'EXPOSITION AUX ONDES RADIO. HPRO est un émetteur-récepteur radio. Il est conçu et fabriqué pour ne pas dépasser les limites d'émission pour l'exposition à l'énergie des radiofréquences (RF) fixées par la Federal Communications Commission du gouvernement des États-Unis et Industrie Canada.