Use Instructions

WWW.QUADLOCKCASE.NET
LOCATION OF TRANSMITTER IN VEHICLE
Immobilizer system only
The transmitter should be installed a safe distance (minimum 10 cm) away
from the immobilizer system (i.e., steering lock or key fob docking station).
Passive start systems
The transmitter should be installed a safe distance (minimum 10 cm) away
from the immobilizer system (i.e., steering lock or key fob docking station).
The transmitter should be installed at minimum 15 cm away from any possible
layo of the key fob, handbag or driver pockets. Ideal position is a vertical
position on the dashboard.
Additional counter measures
If the above mentioned safe recommended distances (4.1.1) can’t be achieved,
other techniques are recommended to be used to avoid interference with
the key fob.
• The charger installation and use instructions notes that the driver
should insert the key fob into the charging slot whenever possible when
operating the wireless charger.
• Charger should only be powered with “accessories” and/or “engine on”
(can’t be applied with permanent powered cigarette lighters).
• To have some margin in timing between key fob authentication and
contact/engine on, the charger should wait a minimum of one second
before starting charge.
With these measures the engine start and car lock problems can be avoided.
Door opening or key fob polling with running engine remain a risk.
STATEMENT OF COMPLIANCE
This device complies with part 15 of the FCC Rules and RSS-Gen of IC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced technician for help.
CAUTION: To comply with the limits of the Class B digital device, pursuant to
Part 15 of the FCC Rules, this device must be used with certified peripherals
and shielded cables. All peripherals must be shielded and grounded.
Operation with non-certified peripherals or non-shielded cables may result in
interference to radio or reception.
To comply with RF exposure compliance requirements, the wireless charging
base must be used with a separation distance of at least 10cm from all persons.
For 10W Fast Charge Mode, a Quick Charge 3.0 adapter must be used for the
power input in conjunction with a 3A USB cable.
“Hereby, Annex products declares that this product is in complacence
with Directive 2014/53/EU. The full text of the EU declaration of
conformity can be found at www.quadlock.com.au/compliance.”
INDUSTRIE CANADA (IC: 27134-QLAWCH3)
This device complies with Industry Canada’s license-exempt RSSs.
Operation is subject to the following two conditions:
• This device may not cause interference; and
• This device must accept any interference, including interference that
may cause undesired operation of the device.
This equipment complies with Canada radiation exposure limits set forth
for an uncontrolled environment.
During the operation of device a distance of 10 cm surrounding the device
and 10 cm above the top surface of the device must be respected.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes:
• l’appareil ne doit pas produire de brouillage;
• l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
Cet équipement est conforme Canada limites d’exposition aux radiations
dans un environnement non contrôlé.
Au cours de l’opération de l’appareil sur une distance de 10 cm autour de
l’appareil et de 10 cm au - dessus de la surface supérieure de l’appareil
doit être respecté.
2105-032
At the time of writing
this colour state does
not appear on iPhones
POWER
ON
NOT
CHARGING
SLOW
CHARGE CHARGING
FULL
CHARGE
WHAT DO THESE LIGHTS MEAN? TURNING OFF INDICATOR LEDS
REMOVING DESK MOUNT HEAD ATTACHING WIRELESS CHARGING HEAD REMOVING CAR MOUNT HEAD ATTACHING WIRELESS CHARGING HEAD
ATTACHING YOUR QUAD LOCK CASE
45
˚
WIRELESS
CHARGING
HEAD
2105-032_Desk WCH v3 - Instructions.indd 12105-032_Desk WCH v3 - Instructions.indd 1 26/7/21 2:28 pm26/7/21 2:28 pm