unIFY Control Panel Axiom BT1Configuration
Connection The unIFY Control Panel software comes with the necessary drivers required by the operating system for compatibility with the BT1 so this should be installed first before connecting the BT1. Once unIFY is installed, connect the supplied mini-USB cable between a PC and the BT1 wall plate. This should power up the wall plate and the Power LED should turn green once the wall plate is ready. *Note: Power supplied via the USB connection is enough to power the BT1 wall plate for initial configuration.
Connected Device Displays the friendly name of the paired/connected device. Bluetooth® Friendly Name Allows user to configure an appropriate Bluetooth® friendly name that will be visible to users on their Bluetooth® equipped devices when attempting to connect. This allows for multiple BT1 devices to be placed in close proximity and still provide clarity to users trying to connect to a particular BT1 device and audio system.
Activate Pairing This function activates pairing mode on the device similar to pressing the front panel button. Close Active Connection This function remotely closes the active Bluetooth® connection and function is only active when the Bluetooth® status is "Connected". Clear Pairing List This function clears the actively paired devices in the pairing list. This is generally not required but may help in resolving any connectivity issues that users experience.
Device Control ID Clicking the ID button allows the device to be visually located. This feature will flash the status LED yellow to allow users to find the physical location of the device. Factory Reset Allows users to return the connected unit to factory default settings. Reboot Allows users to remotely trigger a reboot cycle of the connected unit.
Firmware Update This button allows users to initiate an update to the device. Updates may be downloaded from the QSC website as available. The following window will be displayed upon pressing the Firmware Update button. Note: Firmware updates must be performed using the USB mini type-B connection ONLY. This CANNOT be done over the Axiom bus. After opening, click the Select File button to choose the appropriate .bin file. Once selected, click Start Update.
