Installation Instructions

Qolsys Z-WaveAH Plus Module

General Applications:

The Qolsys Z-WaveAH Plus Module features the 500 series Z-Wave Wireless Microcontroller silicon from

Sigma Designs, providing an air interface to certified Z-Wave devices. OEMs that integrate this module

will be able to connect to a variety of smart devices for home automation and control, for example:

thermostats, door locks, light bulbs, and electrical outlets. Note: these smart devices must be Z-Wave

certified.

Installation and Operation:

The module has a simple 8 pin header interface for power, reset, and UART connections. The mounting

screw is required for mechanical stability and to ensure a robust ground connection. The antenna is

permanently fixed to the module. Do not place any large pieces of metal around or near the antenna, as

it will inhibit performance. Do not modify the antenna in any way. This module is installed in a final

product which is intended to be a minimum of 20 cm or greater away from user in normal operation.

PAGE 1
Qolsys Z-WaveAH Plus Module General Applications: The Qolsys Z-WaveAH Plus Module features the 500 series Z-Wave Wireless Microcontroller silicon from Sigma Designs, providing an air interface to certified Z-Wave devices. OEMs that integrate this module will be able to connect to a variety of smart devices for home automation and control, for example: thermostats, door locks, light bulbs, and electrical outlets. Note: these smart devices must be Z-Wave certified.
PAGE 2
The Qolsys Z-WaveAH Plus Module operates at 919.8 / 921.4 MHz with an output power set at 0 dBm with trace and filter loss is approx.. 1.3 dbi. Data and protocol specifications are beyond the scope of this document. Please contact Qolsys for the technical specifications. Pin Configuration: 3.3 v SRF Rx SRF Tx 1 2 3 4 SRF RST SRF Wake Not Used Not used 5 6 7 8 FCC Compliance: FCCID: 2AAJXQS-ZWAVE This device complies with part 15 of the FCC Rules.
PAGE 3
a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.