Quick Guide

STEP

IQ MICRO DW S-LINE QUICK INSTALL GUIDE

✓

Exterior Doors

✓

Sliding

glass

doors

Windows

✓

CHOOSE

INSTALLATION

LOCATION

Also great for:

Medicine cabinets

Gun safes

Garage doors

Interior doors

SPECIFICATIONS

SEE REVERSE FOR REMAINING STEPS

Sensor: 1.83”H x .87”W x .4”D

Wireless signal range: 600ft (200M), open air.

Code outputs: tamper, tamper restore, alarm, alarm

restore, low battery.

Transmitter frequency: SECURE 319.5 MHz (S-Line)

Unique code ID

Supervisory keep-alive interval: 70 minutes.

RF Peak Strength: 69.32 dBμV/m at 3m

Operating Temperature: -10C~50C

Relative Humidity: 5-95% Non-Condensing

Storage Temperature: -40-80C

Replace battery with 3V Lithium (x1).

(1) -Panasonic CR1632

-Energizer CR1632

-Duracell DL1632

This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)

PAGE 1
IQ MICRO DW S-LINE QUICK INSTALL GUIDE STEP CHOOSE INSTALLATION LOCATION 1 Also great for: Medicine cabinets Gun safes SPECIFICATIONS Garage doors Interior doors Sensor: 1.83”H x .87”W x .4”D Exterior Doors ✓ ✓ Sliding glass doors Windows ✓ SEE REVERSE FOR REMAINING STEPS Wireless signal range: 600ft (200M), open air. Code outputs: tamper, tamper restore, alarm, alarm restore, low battery. Transmitter frequency: SECURE 319.5 MHz (S-Line) Unique code ID Supervisory keep-alive interval: 70 minutes.
PAGE 2
STEP REMOVE BATTERY TABS 2 STEP APPLY ADHESIVE 3 STEP 4 LINE UP SENSOR & MAGNET STEP 5 SECURE SENSOR & MAGNET Magnet locator mark Magnet STEP 6 1” Apply provided adhesive strips to the back of sensor and magnet. Magnet gap should not exceed 1” Sensor LEARN INTO PANEL ADD Place your panel in “autolearn" mode Open and close the case to “tamper” the device Document#: IQ-MICRO-SQG-12-18 Qolsys Inc. proprietary. Revision#: 1/9/19 Reproduction without permission is not permitted.