EXXXX Jing Si E-Book TZ-901 E-Reader Quick Start Guide
DRAFT v3 Package contents Micro USB cable Power adapter Jing Si E-Book TZ-901 Quick start guide Leather holster Technical documentations and warranty card NOTES: • If any of the items is damaged or missing, contact your retailer. • Do not put your TZ-901 E-Reader in an environment with direct sunlight or with a temperature above 50oC. Doing so may damage your TZ901 E-Reader. • Refer to the user manual saved in your TZ-901 E-Reader for more information.
Getting to know your TZ901 E-Reader Top view Power button Front view Touch screen panel Home button Previous/Scroll up button Next/Scroll down button TZ-901 Quick Start Guide DRAFT v3 DRAFT v3 DRAFT v3
DRAFT v3 Bottom view Audio speakers Left view Right view DRAFT v3 DRAFT v3 Volume button microSD card slot micro USB 2.
Charging your TZ-901 E-Reader To charge your TZ-901 E-Reader: Connect the micro USB cable to the power adapter. Plug the micro USB connector into your TZ-901 E-Reader. Plug the power adapter into a grounded power outlet. Charge your TZ-901 E-Reader for six (6) hours before using it in battery mode for the first time.
DRAFT v3 Turning your TZ-901 E-Reader on DRAFT v3 DRAFT v3 To turn your TZ-901 E-Reader on, press the power button for about three (3) seconds. NOTES: • To wake your TZ-901 E-Reader from standby mode, press the power button. • In the event that your TZ-901 E-Reader becomes unresponsive, press and hold the power button and the Home button at the same time to restart your TZ-901 EReader.
Saving files in your TZ-901 E-Reader DRAFT v3 DRAFT v3 DRAFT v3 To save files from your compter to your TZ-901 E-Reader: 1. Plug the micro USB connector into your TZ-901 E-Reader. 2. Plug the micro USB cable to your computer’s USB port. 3. On your TZ-901 E-Reader, tap Connect to PC. 4. On your computer, open Computer > TZ-901 then save your files in your TZ-901 E-Reader. IMPORTANT! To save audio files and book files, ensure that you save them in their corresponding folders.
Installing your TZ-901 E-Reader to the leather holster To install your TZ-901 E-Reader to the leather holster: 1. Open the bundled leather holster. 2. Place the TZ-901 EReader facing up then insert and slide it to the leather holster until it fits to the holders, as shown. 3. Snap the lower end corners of the TZ-901 E-Reader to the leather holster’s holders in place.
Appendices Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: • This device may not cause harmful interference. • This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment. The antenna(s) used for this transmitter must not be colocated or operating in conjunction with any other antenna or transmitter.
DRAFT v3 The highest SAR value for the device as reported to the FCC is 1.27 W/kg when placed next to the body. DRAFT v3 DRAFT v3 The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this device is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: VRSTZ901.
DRAFT v3 DRAFT v3 DRAFT v3 12 TZ-901 Quick Start Guide