Crystal LED Lamp User Guide English
Introduction Thank you for purchasing the Coral LED (Light-Emitting Diode) Table Lamp. To ensure your safety against any potential hazards and to optimize your lighting experience, please read this guide carefully prior to use, and keep it in a safe place for future reference. Features The features of this lamp include: English • Modular units that can be assembled: units of Crystal LED Lamp can be ssembled to create various combinations either while on or off.
In case of the following situations, unplug the lamp from the power outlet immediately and contact the authorized service center or a qualified service person for inspection or repair: WARNING • Do not use the lamp in a humid environment (like in a bathroom or outdoors). Otherwise the components inside may short-circuit and result in accidents. • The lamp containes magnets. To avoid any damage or malfunction, the lamp should be kept away from objects containing iron or magnetic materials (e.g.
2. Assembling the Crystal LED Lamp units Each unit of Crystal LED Lamp can be connected to other units. Therefore, you can follow these instructions to assemble units and create various combined integral: (A) Master Unit (B) Slave Unit a. Align the contact faces on the two units (as illustrated contact pins), in order to assemble the two units. Pay attention to the polarity of magnets: Opposite polarities on the units will attract and like polarities will repel. Contact pins English Contact pins b.
Operate the Crystal LED Lamp with remote control Turning on the Crystal LED Lamp When the Crystal LED Lamp is on standby, push the Power button on the remote control to turn on the Crystal LED Lamp. (E) Mode Turning off the Crystal LED Lamp English When the Crystal LED Lamp is turned on, push the Power button on the remote control again to turn off the Crystal LED Lamp (dimmed).
Maintenance and Troubleshooting Cleaning the Lamp Turn off the lamp first, and unplug the lamp from the power outlet. Use a soft and dry cloth to wipe any smears or dusts off the lamp's outer casing. Do not use any chemical solvents like kerosene, naphtha and so on, as the lamp's casing may become damaged. Cleaning the Wiring • Use only a dry and soft cloth to wipe the lamp's wiring clean. Never use a wet cloth, as it may cause an electric shock.
Specifications • Model: NV01, NV01 _6, NV01 _8, or NV01 _12 • Unit Dimensions (Lx Wx H): 73mm x 73mm x 73mm • Power input: AC Input 100-240V 50-60Hz 0.6A, DC Output 15V 1.6A • Power Adapter: FSP024-DMCE1 • Max Power Consumption (16 units): 15W • Operating Temperature: 0 C - 40 C Assembly Examples You may use different combinations of master and slave units to create your Crystal LED Lamp assembly.
Regulatory Information FCC Compliance Notice English This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.