User’s Guide for the Qing Lei’s Vital Signs Monitor
1.
2. Installation and configuration The following preparations must be made before installation and configuration: a) Confirm that there is a WIFI signal in the room, and the WIFI name and password are known; b) A mobile phone connected to the room’s WIFI network is needed; c) A tape measure or ruler is needed; d) A dry rag is needed. Install the base Please make a mark on the wall at the position of 1.
底座 墙 床 Bed 底座 墙 1.2m Wall Bed 床 Figure 2 Connect power supply Connect the data cable to the power supply port of the device and the power adapter, then turn on the power, and the device will start working. Replace/reset network In the power-on state, long press the "W" hole of the monitor body with a needle. When the monitor emits a green light, it will enter the one-key network configuration mode. At this time, you can release the "W" key.
official account. Follow the official account, and select the “We-Chat net-configuration” in the menu bar. Enter the WIFI network password of this room, click "Connect". A few seconds later, it will prompt "Network configuration succeeded". At this time, the device has successfully connected to the network. (If the network configuration is failed or time out, please retry the above steps).
3. Basic parameters Product name: Vital Signs Monitor KY-22 Rated power: 0.75W Rated voltage: 5V The main body size of the monitor: φ64mm * 36mm Product net weight: about 60g Use environment: indoor only Wireless connection: 802.11 b/g/n Wi-Fi @ 2.
FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.