Qingdao Intelligent & Precise Electronics Co., Ltd ZDGF7668AU-FT User Manual Product Name:IEEE 802.11 a/b/g/n/ac 2.4GHz+5GHz 2T2R, Bluetooth 5.
1. Introduction Thank you for using the Wi-Fi module product provided by Qingdao Intelligent &Precise Electronics Co., Ltd. Before use, please read this user manual carefully. Please follow the technical specifications when using the module in your design and develop activities. Qingdao Intelligent &Precise Electronics Co., Ltd has the right to change the contents of this manual in accordance with the needs of the technical development.
To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or more should be maintained between the antenna of this device and persons during device operation. To ensure compliance, operations at closer than this distance is not recommended. Les antennes installées doivent être situées de facon àce que la population ne puisse y être exposée àune distance de moin de 20 cm.
●support WFA/ WPA/WPA2 /WPS2.0/WAPI security ●RoH ●MAC /baseband/RF: MT7668AU 3. Product Specification 3.1 Parameter WLAN Standard IEEE802.11a/b/g/n/ac Data Interface USB2.0 WLAN Modulation Mode WIFI: 802.11b:CCK, DQPSK, DBPSK 802.11a, 802.11g:64QAM, 16QAM, QPSK, BPSK 802.11n:64QAM, 16QAM, QPSK, BPSK 802.11ac:256QAM, 64QAM, 16QAM, QPSK, BPSK WLAN Working Frequency 2.4G: 2400-2483.5MHz; 5G: 5150-5350 MHz, 5470-5850 MHz . WLAN Receiver Sensitivity 11b @ 11Mbps: (Max.
4. Hardware information 4.1 structure dimension:(Unit:mm) PCB Material:FR-4,Surface treatment:OSP. Appearance Dimension(mm) :70(+/- 0.3)×33(+/- 0.3) PCB thickness:1.0mm(+/-0.15mm). Via:Ф4mm(+/-0.15mm). 4.2 PIN definition NO Description 1、2、3 VCC 4 GND 5 GND 6 BTDN 7 BTDP 8 GND 9 GND 10 BT_REG_ON(原规划的 REG_ON) 11 WLAN_DEV_WAKE 12 BT_HOST_WAKE 4.
5 EU single contact point Hisense Czech (Manufacture) s.r.o. U Nové Hospody 1164/4, 301 00 Plzeň ,Czech Republic. 6 Manufacture’s postal address No.218, Qianwangang Road, Qingdao Economic & Technological Development Zone, Shandong, China 7 Importer’s name & address Hisense Czech (Manufacture) s.r.o. U Nové Hospody 1164/4, 301 00 Plzeň ,Czech Republic.
8. The requirement for KDB 996369 D03: 8.1 List of applicable FCC rules FCC Part 15. 247 and FCC Part 407. 8.2 Summarize the specific operational use conditions None 8.3 Limited module procedures The module is a single module, so this requirement is not applicable to the product. 8.4 Trace antenna designs The module uses the permanent PCB antenna, so this requirement is not applicable to the product. 8.