NFC_V3 User Guide
1. Abstract RFID antenna board through the GD32F130 master controller, control NXP663 13.56M NFC antenna controller for NFC electronic tag reading and writing.
1.2. Appearance and interface diagram Name Antenna board assembly Antenna board Antenna data control board Hall induction board Hall induction wiring Main technology parameters Technology parameter Input voltage 5V, output voltage 5V, working current <200mA, static current <60mA Size:461mm(length)*116mm(width) *1.60mm(thickness); The transmission frequency is 13.56M Dimension:461mm(length) *106mm(width 1)*20mm(width 2) 1.6mm(thickness); Power supply 5V input, 3.
The main component of the antenna board:
NO.
1.3.
1.4.
Federal Communications Commission (FCC) Interference Statement The limited modular transmitter is only FCC authorized for the specific rule part (FCC Part15.225) listed on the grant, and that the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification. This device complies with Part 15 of the FCC Rules.
OEM Integration Instructions: This device is intended only for OEM integrators under the following conditions: The module can be used to installation in other host. And the transmitter module may not be co-located with any other transmit or antenna. The module shall be only used with the integral antenna(s) that has been originally tested and certified with this module. This module must not be incorporated into any other device or system without retesting for compliance as a composite system per Part 2.