User's Manual

1). Make sure add the fingerprint before using. Any finger can unlock in the factory
setting
2) In order to keep the lock work well, to add no less than 3 fingerprints
Note
2. How to delete fingerprints
→Put any registered on sensor, green light, holding, green light again, keep holding,
green light then red light flashed, then remove
→green light for 2 seconds, all the fingerprints deleted
Registered
Holding
Light color change
Automatic Mode
1. How to add new fingerprints
→Put a finger on sensor, green light and latch retracts, holding, green light and latch
comes out, keep holding, green light on, then remove
→Blue light, put a finger on, green light then remove
→Put the finger on, green light then remove; repeat until a long green light for 2 seconds
(The fingerprint is registered)
→Blue light, add more new fingerprints
light
Registered
Step 1
Step 2-3
Step 3
Step 4
Finger 1
Repeat
Long green light
Finger 2
3. How to lock
→Push the door closed, door lock automatically
FINGERPRINT CABINET LOCK
USER MANUAL
1.Biometric sensor, high sensitive and rapid responsive
2. Max 20 fingerprints to hold for multiple users
3. E-Key for emergency key and management
4. ABS panel with elegant design
5. surface mounted, widely used in drawer, cabinet, wardrobe etc.
Feature
4. How to unlock
→Put any registered fingerprint on sensor
→Green light, unlocked
→Pull the door open
1.Insert E-Key
2.Put any finger on sensor, green light flashes twice, unlocked
3.Pull the door open
Other Function
E-Key
Any finger
When low battery, can connect power bank or mobile plug for outer power
supply
After unlocked, change the battery immediately
In case of low battery, to put on the registered fingerprint, green light flashes
once, and red light flashes thrice, then a long green light, unlocked. To
change the battery immediately after door open
Note: Use 3XAAA alkaline battery, not take carbone battery
2. Low battery warning
3. Outer Power Supply
Power
bank