Use and Care Manual

Use the QEP

Diamond Hole Saw Kits to drill holes when installing bathroom ﬁxtures on various tile surfaces

including the hardest porcelain, ceramic, marble and granite. These drills feature a metal saw with diamond grit

edge for long lasting use, limited wear, faster cuts, less dust and less chipping. In addition to the hole saw, each kit

contains adhesive pads, a water cooling system and drill guide. This hole saw must be used with the water system

to keep it from overheating and must be used with a cordless drill.

www.QEP.com

Professional Tools for Professional Results

Diamond Hole Saw

10571 / 10572

5/16" Diamond Hole Saw with

Water Delivery System

10571

Blister card packaging

PAGE 1
Diamond Hole Saw 10571 / 10572 10571 5/16" Diamond Hole Saw with Water Delivery System Blister card packaging Use the QEP® Diamond Hole Saw Kits to drill holes when installing bathroom fixtures on various tile surfaces including the hardest porcelain, ceramic, marble and granite. These drills feature a metal saw with diamond grit edge for long lasting use, limited wear, faster cuts, less dust and less chipping.
PAGE 2
How To Use A B 1. Mark where the hole is to be drilled. 2. Be sure that the blue Drill Guide is flush to the Water Reservoir. 3. Peel paper from one side of Mounting Tape and attach to the surface of the blue Drill Guide, centering the hole around the lip. Press firmly. (A) 4. Remove cap on Water Reservoir and fill with water to bottom edge of the Drill Guide. Reattach cap firmly. (B) 5. Remove remaining paper from Mounting Tape.