Bluetooth Module QBTM400 User’s Manual
Contents 1. Contents 2. Introduction 3. Bluetooth Basics 4. Installation Overview 4.
2. Introduction Thank you for purchasing Bluetooth Module. This manual will assist you with the installation procedure. The package you have received should contain the following items: • Bluetooth Module • User manual • CD containing Wireless LAN Management utility and driver software.
3. Wireless Bluetooth Basics Wireless Bluetooth systems offer a great number of advantages over a traditional, wired system. Wireless Bluetooth are more flexible, easier to setup and manage and often more cost effective than their wired equivalence. Using radio frequency (RF) technology. Bluetooth transmits and receives data over the air, minimizing the need for wired connections. Thus, Bluetooth combines data connectivity with user mobility, and, through simplified configuration, enable movable LANs.
4. Installation and Overview Here are some steps you will perform in establishing your wireless network connection: • Install Bluetooth Utility using the Installation CD.
4.1 Installation Procedures of Bluetooth Utility Under your windows environment, go to Start Æ Settings Æ Control Panel Æ System Æ Hardware Æ Device Management to check whether Bluetooth Radios is detected.
4.2 Installation Driver and Bluetooth Utility 1. Insert the installation CD into your CD-ROM drive. The Main Menu would display, select Application/Driver Installation. 2.
3. The welcome window will appear, please click Next 4.
5. Click Next to install to this folder 6. Wait, while BlueSoleil Setup is performing the request operations.
7.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: 1) The transmitter module may not be co-located with any other transmitter or antenna. As long as conduction above is met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed (for Notebook).
