802.
Installation Instructions **End Product Labeling: The Final end product label must contain the following statement on the product label: “Contains FCC ID: RUJ-LR802URN3 ** End Product user’s manual: The end product user manual must contain the following statements; For Customers in the United States "IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not b
Windows 7 Driver Installation 1. For installing the Wireless LAN Card driver, go to the directory where the Wireless Adapter Installation stored, then double-click the Setup program to begin the installation. 2. Realtek Wireless LAN Setup Wizard is preparing the setup. Click NEXT.
3. The Realtek Wireless LAN driver is installing. Please wait. 4. When the Realtek Wireless LAN – Install shield Wizard screen disappears, the installation of Realtek Wireless LAN driver is now complete. Click Finish 5. System Reboot. 6. When you complete the installation, the utility icon will appear on the system tray ( network settings. ).
Uninstalling the Wireless LAN Card 1. For uninstalling the Wireless LAN Card, please go to: Control Panel Program and Features 2. Under Windows environment. Right -click the "REALTEK Wireless LAN Driver and Utility", and then click "Uninstall".
3. Realtek Wireless LAN Setup Wizard prepares to uninstall the driver on your system. Please wait. 4. Click "Yes" to uninstall the Wireless LAN Card driver and utility. 5. Wait for removing the driver and utility. After completing the uninstalling, click the Finish.
Configuring the Wireless LAN Card Double-click the utility icon configuration. in your system tray to begin the utility Connecting to an existing network 1. Click the Available Network Tab, all available Access Points would be listed. Click on the desired Access Point, and click "Add to Profile". 2. Wireless Network Properties 2-1. Click “OK” if you connect to an unsecured network.
2-2. If you connect to a secured network please type the network security key or passphrase and then click “OK”. 3. Wireless network connection is completed ( see General Information Tab).
Windows 8 Driver Installation 1. For installing the Wireless LAN Card driver, go to the directory where the Wireless Adapter Installation stored, then double-click the Setup program to begin the installation. 2. Realtek Wireless LAN Setup Wizard is preparing the setup. Click NEXT.
3. The Realtek Wireless LAN driver is installing. Please wait. 4. When the Realtek Wireless LAN – Install shield Wizard screen disappears, the installation of Realtek Wireless LAN driver is now complete. Click Finish 5. System Reboot. 6. When you complete the installation, the utility icon will appear on the system tray ( network settings. ).
Uninstalling the Wireless LAN Card 1、 For uninstalling the Wireless LAN Card, please go to: Control Panel Program and Features 2、 Under Windows environment. Right -click the "REALTEK Wireless LAN Driver and Utility", and then click "Uninstall".
3、 Realtek Wireless LAN Setup Wizard prepares to uninstall the driver on your system. Please wait. 4、 Click "Yes" to uninstall the Wireless LAN Card driver and utility. 5、 Wait for removing the driver and utility. After completing the uninstalling, click the Finish.
Configuring the Wireless LAN Card Double-click the utility icon configuration. in your system tray to begin the utility Connecting to an existing network 1. Click the Available Network Tab, all available Access Points would be listed. Click on the desired Access Point, and click "Add to Profile". 2. Wireless Network Properties 2-1. Click “OK” if you connect to an unsecured network.
2-2. If you connect to a secured network please type the network security key or passphrase and then click “OK”. 3. Wireless network connection is completed ( see General Information Tab).
