Full Product Manual

ManualsBrandsQ-STOVES ManualsOutdoor HeatingQ-Flame 79 in. 72,000 BTU Wood Pellet Outdoor Heater

Operation Manual

OUTDOOR WOOD PELLET HEATER

Model: Q 05

WARNING:

 FOR OUTDOOR USE ONLY: This outdoor patio heater is for outdoor use only, and

should only be used in a well ventilated area. This product is NOT to be used

indoors.

 DO NOT: Store or use any flammable liquids or solid combustibles in or near this

product.

IMPORTANT:

Your safety is very important, please read this manual thoroughly before you install,

operate or maintain this heater. Keep this manual for future reference. If you have

questions about assembly, operation, service or repair of this stove, please reach us

directly.

WARNING:

FOR OUTDOOR USE ONLY!

HOT SURFACE WHEN BURNING! KEEP CHILDREN AND

PETS AWAY.

Summary of content (11 pages)

PAGE 1
Operation Manual OUTDOOR WOOD PELLET HEATER Model: Q 05 WARNING:  FOR OUTDOOR USE ONLY: This outdoor patio heater is for outdoor use only, and should only be used in a well ventilated area. This product is NOT to be used indoors.  DO NOT: Store or use any flammable liquids or solid combustibles in or near this product. IMPORTANT: Your safety is very important, please read this manual thoroughly before you install, operate or maintain this heater. Keep this manual for future reference.
PAGE 2
SAVE THIS MANUAL FOR FUTURE REFERENCE Table of Contents Important Warnings…………………………………………….…………………………………………….2 T h a n k Yo u … … … … … … … … … … …… … …… …… … …… … … …… … …… … … …… … … …… … … …… 3 Specification………… …………………………………… …………..…………………………………………3 Important Safety Precautions………………………………..………………………………………….3 Assemb ly……… ……………………………………… …………… …..…………… ……………………………4 Insta ll ation………………………………………………………………………….…………………………….9 Operation………………………………………… …… …………… …… ……… .
PAGE 3
Specifications* Model No………………………………………………………………………………………………………. Q05 Type of Fuel………… wood pellets1/4’’ (.006cm) diameter by 1/2’’ (.012 cm) Input rating……………………………………………………………………………………. 70,000 BTU/HR O ve ra l l He ig ht ……… ……… ………… ……… …………… …… …………… …8 0 ” (2 . 03 2 M) Stove Height………………………………28/19” (.71/.48cm) (with/without hopper) Stove Diameter…………………………………………………………………………………….12” (.30cm) Reflector Diameter………………………………………………………………………………….20” (.5cm) Chimney Diameter…………………………………………………………………………………….
PAGE 4
This outdoor patio heater must be used for outdoors only in a well ventilated area and not be used in a vehicle or any enclosed building or space. Always place the heater on a level stable surface. Do not move or touch the heater while it is hot or burning. Do not alter or modify the heater in any manner. Always keep at least a 3 ft. (.914 m) clearance from the heater to any combustible material. This Heater is to be used on a flat level non-combustible surface only.
PAGE 5
Tools required for assembly are: Phillips Screwdriver pliers 1.1 Unpacking Carefully remove the all parts from the box. The paint on the stove is not fully cured until after you fire the unit on its initial firing, so use care when handling painted parts and put them onto soft surface.
PAGE 6
1.2 Checking Every Part: Inspect the contents of your new heater for shipping damage or missing pieces or hardware. 1.3 Installing the feet: Lean the base of the heater back or lay and its front to thread in the feet to the bottom.
PAGE 7
Assemble the ash drawer handle by installing 2 screws and nuts to the tray. Then slide it into place. Install the section of chimney on the base of the unit that does not have the damper. Then install the damper section next. Interlock the stove pipe so they lock into place and are even at the edges. Fit the longer section to the screened section.
PAGE 8
Thread the 3 screws through the tabs into the deflector disk. Then attach the long section of stove pipe to the completed screened section. Place the top stack onto the heater assembly. Once the stove pipes are firmly fitted together it is complete.
PAGE 9
Installation 2.1 Installation warning The installation must conform with local, state and federal codes. In absence of such codes, install in accordance with the current American National Standard (ANSI)/National Fire Protection Association (NFPA) codes. 2.2 Minimum clearances A minimum 3 ft. (.914 M) clearance from this heater and all its parts to combustible materials must be maintained at all times while the heater is in operation. 2.
PAGE 10
and combustion chamber. Pellets collect moisture when exposed to the air making them less flammable and will swell and stick to metal surfaces. 4.3 Store the heater upright in a sheltered area away from weather such as rain, snow and dust. 4.4 This unit is manufactured as an “Outdoor Unit’’ from steel. If you leave it in the weather it will accumulate rust. This is normal and can be treated by using high temp spray paint not included with the heater. 5. Maintenance 5.
PAGE 11
Patent Pending: QSTOVES INC. Copyright 2016 All Rights Reserved SEE MORE STOVES AND FIREPLACE PRODUCTS, CHECK THE ELECTRONIC VERSION OWNER’S MANUAL AND INSTALLATION VIDEO, PLEASE VISIT: WWW.QSTOVES.COM WEAR PROTECTIVE GLOVES WHEN ASSEMBLING. CAUTION! PAINT IS EXTREMELY FRAGILE PRIOR TO CURING. GENTLY UNWRAP ALL PARTS. DO NOT SET PAINTED PARTS ON ABRASIVE SURFACES. Version 5.