PDWM8225 PDWM8250 PDWM8275 PDWM8225 - PDWM8250 - PDWM8275 Wireless Microphone System
CATALOG 1. FOREWORD --------------------------------------------------------------------------------------------- 2. INTRODUCTION --------------------------------------------------------------------------------------- 3. SYSTEM FEATURES 4. SYSTEM TYPE 2 2 ----------------------------------------------------------------------------------- 2 ------------------------------------------------------------------------------------------- 2 5.
FOUR CHANNEL RECEIVER FEATURES 1. Power Button: Power ON/OFF the receiver. 2. Down Function Button: Sets channel data. 3. "RF" Signal lndicator: lt glows when the Receiver receive RF signal from Transmitter. 4. LCD Information Display: Show the receiver frequency channel ect. 5. Volume Knob: Adjust the volume output of receiver. 6. Up Function Button: Sets channel data. 7. AF Audio Level Indicator: Indicate the wireless system audio signal level. 8. Antenna. 9.
BODY-PACK TRANSMITTER FEATURES TRANSMITTER BATTERY INSTALLATION 1. Battery Installation of Handheld Microphone: Open the battery cover. Insert the supplied batteries into battery jar in polarity and cover the battery. 1. Power and Audio Mute Switch. 2. Antenna: Transmit the RF signal of transmitter. 3. Belt Clip: Attach the transmitter to the belt. 4. Audio Input Jack: Suitable for lavalier system/headset system. 5.
BODYPACK TRANSMITTER CONNECTION 1. Lavalier Microphone Connection: Connect the connector of supplied lavalier microphone to the connecting jack of transmitter (shown as below) Set the transmitter work state in wireless lavalier system (L). 2. Headset Microphone Connection: Connect the connector of supplied headset microphone to the connecting jack of transmitter (shown as below) Set the transmitter work state in wireless headset system (H). b.
SYSTEM CONNECTION TROUBLESHOOTING 1. Receiver Power Connection: Connect the DC connector of supplied AC/DC adapter Into the DC power input of receiver. Plug the AC Input connecter into an AC120/60Hz or AC220V/50Hz outlet. (Shown as below) 2. Antenna: Keep the position of antenna at a 45 angle from vertical. (Shown as below) 3. Audio Connection: Connect the corresponding output of receiver by supplied 1/4w phone jack audio cable or your XLR cable to the Input of power amplifier, mixer.
HAND-HELD TRANSMITTER SPECIFICATIONS SYSTEM SPECIFICATIONS • RF Carrier Frequency Range: Approximately 523 to 597.8 MHZ (Available frequencies depend on applicable regulations in country where system is used). • Operating Range: 50m (approximately 164ft) under typical conditions • Audio Frequency Response: 100 to 18,000Hz, ±3dB • THD: <1% • Mobile state Range: > 100dB Power Requirements 1.