LED PDWM 4520 PDWM 4540 PDWM 4560
CATALOG 1.FOREWORD.................................................................................2 2.INTRODUCTION...........................................................................2 3.SYSTEM FEATURES.....................................................................2 4.SYSTEM TYPE..............................................................................2 5.FOUR CHANNEL RECEIVER FEATURES.........................................
FOUR CHANNEL RECEIVER FEATURES MICROPHONE-TRANSMITTER FEATURES 6 1 5 1 2 5 3 4 3 5 4 3 5 4 3 3 4 Front Panel 4 ON 2 6 7 8 9 6 Rear Panel 1.Power Button: Power ON/OFF the receiver. 2.Power Indicator: Indicate the power ON/OFF. 3."AF"Audio Level Indicator: Indicate the wireless system audio signal level. 4.Volume Knob: Adjust the volume output of receiver. 5."RF" signal Indicator:It glows when the Receiver receive RF signal from Transmitter. 1.
BODY-PACK TRANSMITTER FEATURES TRANSMITTER BATTERY INSTALLATION 1. Battery Installation of Handheld Microphone: Open the battery cover, Insert the supplied batteries into battery jar in polarity and cover the battery cover. 4 1 5 2 3 Push down to open. 7 6 1. Power and Audio Mute Switch. 2. Antenna: Transmit the RF signal of transmitter. 3. Belt Clip: Attach the transmitter to the belt. 4. Audio Input Jack: it is suitable for lavalier system/headset system. 5.
BODYPACK TRANSMITTER CONNECTION 1. Lavalier Microphone Connection: Connect the connecter of supplied lavalier microphone to the connecting jack of transmitter (shown as below) Set the transmitter work state in wireless lavalier system(L). 2. Headset Microphone Connection: Connect the connecter of supplied headset microphone to the connecting jack of transmitter(shown as below) Set the transmitter work state in wireless headset system(H). SYSTEM CONNECTION 1.
TROUBLESHOOTING The audio gain control on transmitter has been factory-at the mid-range position for best performance in most applications.This may be necessary for soft singers or talkers, or guitar or basses with Iow outputs. To Increase Gain: Rotate the transmitter gain control clockwise with the screwdriver to increase audio gain. To Reduce Gain: Rotate the transmitter gain control counterclockwise with the screwdriver to reduce audio gain.
RECEIVER SPECIFICATION Power Requirements 120V or 230V AC adaptor with 2.1 mm female plug Power Requirements 13-15 V DC nominal, 500mA Signal/Noise Ratio MORE THAN 85dB Border Upon Channel Rejection MORE THAN 70dB Image & Spurious Rejection MORE THAN 70dB Audio Output Level 0- Receiving Sensitivity Dimensions -105dBm 300mV 394MM X 235MM X 55MM HAND-HELD TRANSMITTER SPECIFICATIONS Power Requirements 1.
Pyle PDWM4540 Wireless Microphone System, UHF Quad Channel Fixed Frequency, 2 Handheld Microphones, 2 Body-Pack Transmitters, 2 Headset & 2 Lavalier Mics, Rack Mountable Pyle PDWM4560 Wireless Microphone System, UHF Quad Channel Fixed Frequency, 4 Body-Pack Transmitters, 4 Headset & 4 Lavalier Mics, Rack Mountable UHF Band Receiver System Quad Frequency Channel Design (Channel 1, 2, 3, 4) Broad Frequency Response Range & Low Distortion High Signal/Noise Ratio Performance RF Signal & AF Signal LED Indicato