User Manual

ManualsBrandsPyle Pro ManualsPro AudioPremier Series 2-Person Wireless Handheld Microphone System

Wireless Microphone System

PDWM2560

Summary of content (6 pages)

PAGE 1
PDWM2560 Wireless Microphone System
PAGE 2
CATALOG 1. FOREWORD - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2 2. SYSTEM FEATURES - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2 3.
PAGE 3
DUAL CHANNEL RECHARGEABLE RECEIVER FEATURES 1. Power Switch: Power ON/OFF the receiver. 2. Volume Knob: Adjust the volume output of receiver. 3. Down Function Button: Sets channel data. 4. LCD Information Display: Shows the receiver’s frequency channel etc. 5. Up Function Button: Sets channel data. TRANSMITTER FUNCTION & FEATURES 1. Grille: Protects the cartridge and helps to reducing breath sounds and wind noise. 2. LCD Information Display: Show the transmitter frequency channel ect. 3.
PAGE 4
1. Power and Audio Mute Switch. 2. Antenna: Transmit the RF signal of transmitter. 3. Belt Clip: Attach the transmitter to the belt. 4. Audio Input Jack: Suitable for lavaliere system/headset system. 5. Low Battery Indicator: Red light glows when it is lack of power and should renew the battery. 6. LCD Information Display: Show thetransmitter frequency channel etc. 7. Gain Adjusting Volume: Adjust the transmitter audio input gain. 8.
PAGE 5
TRANSMITTER BATTERY INSTALLATION 1. Battery Installation of Handheld Microphone: Open the battery cover. Insert the supplied batteries into battery port observing polarity and close the cover. 2. Battery Installation of Body pack Transmitter: Push open the battery cover. Insert the supplied batteries into battery port observing in polarity and close the cover. TROUBLESHOOTING PROBLEM No Sound 7 If the battery is inserted properly, replace with fresh battery.
PAGE 6
SYSTEM SPECIFICATIONS HAND-HELD TRANSMITTER SPECIFICATIONS • RF Carrier Frequency Range: Approximately 573 to 597.8 MHZ (Available frequencies depend on applicable regulations in country where system is used). • Operating Range: 50m (approximately 164ft) under typical conditions • Audio Frequency Response: 100 to 18,000Hz, ±3dB • THD: <1% • Mobile state Range: > 100dB Power Requirements 1.