i USE MODEMS p65 Pan-European Approval The equipment has been approved in accordance with Council Decision 98/482/EC for pan European single terminal connection to the public switched telephone network (PST. However, due to differences between the individual PST's provided in different countries, the approval does not, of itself, give an unconditional assurance of successful operation on every PST network termination point.
= US3 MUN 065 A taint of 3 calls transepts are allowed 0 3 telephone number, with a minimum period between calls of 2 seconds: if the call doesn’t connect after 3 attempts, 30 minutes must expire before automatic radiating may be initiated.
USB Modernism Label. This includes customer equipment previously labeled, permitted or certified. Notice for New Zealand Users The grant of a Permitted for a device in no way indicates Telecommute acceptance of responsibility for the correct operation of that device under all aerating conditions. In particular the higher speeds at which this modem is capable of operating cannot always be expected an network designed to delivery voice telephony be customers.
0 USB MONGODB, 065 * When used in the Alta Answer made, the SO register must be set with a value between 2 and 10. This ensures: A person calling your modem will hear a short burst of ringing before the modem answers, This confirms that the call has been successfully switched through the network. Caller identification information {which occurs between the first and second ring cadences) is not destroyed. This equipment does nat fully meet Telecommute impedance requirements.
i] US3 MODEM 08 General Conditions As required by PTC 100, please ensure that this office is advised of any changes to the specifics. dons of these products which might affect compliance with the relevant PTC specification.
I USB MODERNISM Before installing the equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunication company. The equipment must also be installed using an acceptable method of connection. In some cases, the company inside wiring associated with a single fine individual service may be extended by means af a certified connector assembly {telephone extension cord).
7 58 MGDEW1.063 son on a soap may consist of any combination of devices subject only to the requirement that the total of the load numbers of all the devices does not exceed 100. FCC Compliance To comply with the applicable seconds of FCC Rules and Regulations, Parts 68 and 1S, cease follow these instructions: Co nat zenned your modem tw a party line or to a coin-operated telephone.
USE MCOEM3.065 FCC Registration Number Ringer Equivalence Number (REN) FCC Part 15 NOTE This equipment has been tested and found ta comply with tne limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection. This equipment generates. uses and can radiated radio frequency energy and. if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
5B MOORE 085 FCC Part 68 Notice This equipment complies with Part 68 af the FCT rules. On the base of this units 2 label that contains, among other information, the FCC registration number and Ringer Equivalence Number (REN) for this equipment. If requested, this information must be given to your telephone company. The REN is used to determine the quantity of devices you may connect w your telephone line and steel have ail of those devices ring when your number is ailed.
0 USS MODERNIZE If the telephone company suspects a problem with your telephone line is related to an add-on electronic device, such as your made, they have the right to temporarily suspend your service. iris your responsibility to remove from the telephone line any malfunctioning electronic communications equipment to avoid damage to the telephone system, If your equipment causes harm to the telephone network, the telephone company may discontinue your service temporarily.
I TSB MODERNISM Table of Contents Chapter 1 Introduction Features System Requirements Package Checklist Chapter 2 Installations Hardware Installation Installation Procedures far Win & Communication Software Installation Chapter 3 Commands Typing Command AT Commands S-Register Definiteness ISI, PM OTT
[Cro e Introduction The Vance / Fax / Data USB Modem with 3 ports HUB connects your computer to Internet, 88S, and other fax modems. 3 ports HUB allows you to connect other USB devices . This manual describes’ the features, installation procedures and AT commands. Features This device supports the following communication standards. IT-T is known as COT. Data + = : © = V.32, V.22bis, V.22, « Bell 103 & 212A = V.42bis & MNP § {Data compression) v V.42 & MN-4 (Error correction) Fax = V.
Chapter © 7] System Requirements * USB Porto PC = Windows™ 98 + 16MB RAM = Pentium 233MHz up CPU Package Checklist The package contains the following items: » Cne USB modem » Cre niece of phone cable © One + The US3 modem user's manual USA Cable / + Sower adapter if any of these items are missing or damaged, please contact your dealer or sales representative for assistance, NOEMI.
[Spews Installations This chapter describes haw to install this device , Hardware Installation Phone © Telephone jack ( to telephone set) Line © Une jack usa © USB Connector to PC : Power jack and RESET DP1.DP3 USB port for other USB devices Note In case this device is down, please unp lug and connect parer plug { SCAN/ ® RETIE )again to reset it . © 1. Plug end of power adapter to marked @; plug another end of power + adapter to wall plug . 2.
Chatterer TT 3. Plug ane end af telephone line to UNE jack marked © plug the other end ta phone outer 4. To use telegraph and the modern on the same fine, plug one end af the atonal here cable inch the PHONE jack marked ©; plug the either end int your telephone Lift the telephone handset and listen for a CI ATONE wo check he connection. w Plug the other end of USB cable ww PC USS port, 6.
& USE MOTE. 08 Chapter 2 5] 3. Please click * Next” 4.
6. After the installation of USB Hub was completed, your system will detect Unknown Device and the fallowing message will appear. dick “ next” . 7. Select the Search for the best driver for your device (Rerecorded) option, then click Next.
ny 3 ' i738 NOEMI 088 2 into your CD ROM drive. Specify the location of the made driver, e.g, {4 NICODEMUS Click Next.
Finish, 11. Please choose country, then click * OK *.
Communication Software Installation S To install the communication software, refer © & the manual contained on the provided CO.
Ti USBMODENI.065 Cope Commands Most people use the communication software programs to tell modems what to do. Therefore, You may not use the commands in this chapter, However, if you prefer to communicate with your made directly, you can type the commands described below. This chapter describes how to work in the terminal mode. The CD bundled in your fax modem Note package contains details on AT commands (file path: X58 MODEMMAT_COMMAND POOF. Typing Commands * Use the BACKSPACE key to delete typing errors.
USE MOORS 068 Chair] 7] * All defaults are based an he &F Hardware Flow Control template goad in RAMON when the modem is shipped. AT Commands Re-executes the last issued command. Used mainly to redial. Go ff-hack and tempt © answer a Cali, Read Selected S-Register, This command reads and displays the selected S-Register. An S-Register can be selected by using tha ASH command, Dias . MDT digits Dw § Pulse arbitrary} idle Tore dial Wait for second dial tone (X3 ar higher); linked 1 $5 register.
I USB MODERNIZE Modem name SW Provider / SW version Chip Vendor Modem active profile Stared profile 0 Stored profile 1 Display stored phone numbers Speaker Control Speaker is always off Speaker ON until CONNECT Speaker is always on. Speaker off during dialing and receiving carrier and tum speaker on during answering.
= USB MODERNISM modem Modulation Data Rates {bps} 22 v.22 1200 122 V.22bis 2400, 1200 32 v.32 9600, 4800 132 V.32bis 14400, 1200, 9600, 7200, 4800 34 33600, 31200, 28800, 26400, 24000, 21600, 19200, 16800, 14400, 12000, 9600, 7200, 4800, 2400 90 V.
071 Chapter S-Register Definitions I USE MODEM 265 so $6 before 87 s8 ss Number of Rings to Auto-Answer The number of rings the modem waits far before it auto answers. Range: 0-255 {rings Default: 0 Wait Time before Blind Dialing The time to pause after off-hook blind dialing. Range: 2-255 (Us) Default: 2 {Country dependent} Waiting Time before Carrier Detect Tha time to wait for a carrier from the remote modem before hanging up.
= USB NOEMI. 65 310 511 Vapor ig! Range: 1-255 Fatuity: 6 {0.6 second) Lost Carrier To Hang Up Delay The tme the modem waits before hanging up for carrier lass. Range: 1-255 Default: 14 (1.4 secants} MDT Tone Duration The dme for MDT ene dialing and . theme wettest the phone spacing, age: 50-255 Default. 9% {0.