| fy | Chapter 3 Uninstalling the 56MR AC-L. Modem To UN-mstall the modem (all builds prior to B 67 preview 12) 1 Open the Windows Device Manager 2. Select the 56MR AC-L Modem from under the Madam key 3. Click the Remove bullion to remove the modem device. 4. Shut down the computer and remove the AMI MDC card {tom the computer. The 56MR AC-L modern software remains on the hard disk.
install on and NEI WA doth vd cht ee Bt ih sdb rot ud She. Pete wp of Ba boning acted Loving Tih feed tht wah © Fred din I” £080 dhe ry P bees she sin FF TRE ! EET Click Nerf) 4 he following confirmation dialog will appear. Bert stereotype wid bed bbe by CONCRETENESS IO) FRR ») Lesa RAL ba 56MR driver files will now be copied. During installation, the system may prompt you for Windows CO. ©.
| y | Chapter 1 Introduction 56M is lipstick Modem Riser (MR) Features This modem supports the following communicant nation standards. IT-T is known a CIT DATA « IT-T V.90 and K56llex Auto-Detect o and V.21 Co Dell 212A and Bell 103 » V.42LAPM and MNP 2-4 error correction « V.42bis and MAPS data compression FAX o and V.21 channel 2 « Group Hi Fax Send and Receive o VITIATE 578 Class KT.3 ax System Requirements o 233 Mitzi Pentium [i Processor with 256K 1.2 cache. « 266Milz Electron Processor Ac-Link V.
“Reorient of relocate the receiving antenna. -Increase the separation between the equipment and receiver, -Connect the equipment into an pullet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced sadist technician for help.
| General Conditions As sequined by PTC 100, please ensure that this office is advised of any changes to the specifications of these products which might affect compliance with the relevant PTC specifications the grant of this Permitted is specific to the above products with the marketing description as stated on the Permitted label artwork.
Notice for New Zealand Users The modem card must only be used in a data terminal equipment (OTE) e.g. computer, that has a screw down cover id. As unseal voltages (TNV} exist on the mate card, disconnect the modem card from the telephone line while the cover (lid) of the DTE {compiler) is removed. card, please ensure there is at East 2mm of air gap between the PCB card and other components in lhe DIE. 1.