Owner’s manual
Controls and Connectors Autotune – press and release to scan UK only Band III. Press and hold for around two seconds to scan the full range of digital frequencies in Band III.
Quick start 1 2 3 4 5 Fully extend the aerial, connect the mains adapter and plug in to your power supply. Push the Standby button if necessary, EVOKE-1XT Marshall Edition switches on, the screen lights up and indicates the progress of a full autotune to find the stations available in your area. Your radio will automaticallly tune to Planet Rock when finished. If no stations are found you see the message ‘No stations available’ and you see a menu of options.
Setting alarms and timers Setting an alarm EVOKE-1XT Marshall Edition has a daily alarm which switches the radio on (if in standby mode) and tunes to the last station or sounds a tone. To set or change an alarm: 1. Press the Menu button to see the current alarm settings. 2. Push the Tune knob if you want to change the alarm settings. 3. Turn the Tune knob to scroll through the following settings and push to change them. The current setting is shown on the top line of the screen.
Setup options Press the Menu button, turn the Tune knob and push to select alarm settings or one of the following setup options. Station order Changes the order of your station list. Select one of the following options: Alphanumeric Displays all stations in alphanumeric order. Fav station Displays your six most listened to stations at the top of the station list and the rest below, in alphanumeric order. Your favourite stations are displayed with a ♥ next to their names.
Display Brightness Change the screen brightness between Low and High. Standby mode Set the Backlight On or Off for when your radio is in standby. Sw version Displays the version of the software in your radio. You may be asked to quote this if you contact Technical Support. Sw upgrade You can upgrade the software in your EVOKE-1XT Marshall Edition using a PC connected to the USB port on the rear panel. To upgrade, select Sw upgrade and follow the instructions provided with the software.
Technical Specifications General Speaker Frequency Range Input connectors Output connectors LCD Display Power supply Approvals Dimensions Stereo digital radio (stereo with optional XT-1 speaker). Fully compliant with ETS 300 401 and capable of decoding all DAB transmission modes 1-4. 3 inch co-axial speaker DAB Band III (174 - 240 MHz) RF F-connector 75 Ω for aerial (telescopic aerial supplied), 9V DC power socket (230V adapter supplied), USB (B type) connector for software upgrades. 3.
This symbol on the product or on its packaging indicates that this product should not be treated as household waste. Instead it should be handed over to a suitable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.