In-Wall Multimedia Amplifier Model # AV-105BT User Manual & Safety Guide www.pure-acoustics.
Thank you for choosing Pure Acoustics. We hope you enjoy each and every use of this product. We suggest that you read this user manual carefully before primary use in order to utilize all of the features in functions installed. Please store it in a safe place for future reference and pass it on to the next owner. Caution & Safety Guide: Please power off the unit when not in use. If the unit will not be in use for extended periods it is suggested that you disconnect the unit from its power source.
In the box: In wall Amplifier External Adapter Audio terminal adapters (right/left x2) Power terminal port adapter Technical Specifications: Amplifier Type: Class D Power Output: 40W (20W x2) Frequency Response: 20Hz - 20 kHz Impedance: 4Ω Infrared Distance: <10 Meters (33ft) Operating Voltage: 110/220V 50Hz/60Hz THD: 0.03% Product Dimensions: 11.5 x 7 x 4.5 cm (4.53 x 2.8 x 1.8 inches) Cutout Dimensions: 10.3 x 6.8 x 4.8 cm (4.05 x 2.7 x 1.
www.pure-acoustics.
Plug n’ Play Connections: • Switch the On/Off button to the “On” positon on the top panel of the device Note: The default mode is USB/SD immediately upon power up • To play songs off of a flash drive - Simply attach the flash drive into the USB port and the device will automatically begin reading the files • Use the AUX input to plug & play music files on your Smartphone, tablet and/or music players • To listen to the radio press the mode button until the device enters FM mode.
Getting Started Locate the area that you would like to install the AV-105BT and mark the spot using a ruler and pencil. You should be able to do this... ...if you're comfortable with these household tasks.. ...and know how to use these tools.
See the chart above to determine which tools you'll need for your wiring project. You'll probably also need a partner to help you with some of the installation steps. Here are some of the tools you may need for your project: (A) electrical tape; (B) measuring tape; (C) a stud finder; (D) a utility knife; (E) a drywall saw; (F) string (for pulling wire short distances); (G) a fish tape (for pulling wire longer distances).
Installing the unit 1. Locate the area where you would like to install the unit in the wall. (Make sure you have access to 110/220V power source) 2. Prepare 110/220V cable length (necessary length varies by job site) 3. Prepare speaker audio cable length according to your needs (0.75mm is preferred) 4. Using the included electrical box trace the area where you would like to install the unit 5. Cutout the marked area using a “fine saw” (extra care should be taken in order to avoid over cutting) 6.
