Installation Instructions

1. This device is a programmable Bluetooth low energy beacon.

2. The equipment is powered by CR2032 battery.

3. The equipment includes 2 monochrome LEDs (red/green) and a touch switch for

developers to use.

4. The initial software version, after power-on, the device will broadcast at an interval of

300ms.

5. The broadcast name is: Puck. js. xxxx (XXXX is 2 bytes after the MAC address).

6. Bluetooth UUID Sever: 6E400001-B5A3-F393-E0A9-E50E24DCCA9E

Notify UUID: 6E400003-B5A3-F393-E0A9-E50E24DCCA9E

Write UUID: 6E400002-B5A3-F393-E0A9-E50E24DCCA9E

PAGE 1
. This device is a programmable Bluetooth low energy beacon. 2. The equipment is powered by CR2032 battery. 3. The equipment includes 2 monochrome LEDs (red/green) and a touch switch for developers to use. 4. The initial software version, after power-on, the device will broadcast at an interval of 300ms. 5. The broadcast name is: Puck. js. xxxx (XXXX is 2 bytes after the MAC address). 6.
PAGE 2
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.