User's Manual

Preliminary manual / shortform for the VIBCONNECT RF 868/915MHz.

For VIBCONNECT RF 2.4GHz necessary changes will be made.

-----------------------------------------

New text on page II :

a) User Information gem. FCC 15.21 enthalten:

Changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

b) Part 15 Statement gem. FCC 15.19/RSS Gen Issue 3 Sect. 7.1.3

This device complies with Part 15 of the FCC Rules and with Industry Canada

license-exempt RSS standard(s). Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils

radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :

(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil

doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible d'en compromettre le fonctionnement.

c) Statement für Class B Digital Device gem. FCC 15.105:

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

—Consult the dealer or an experienced radio/ TV technician for help.

-----------------------------------------

Postion of FCC-label is not shown on page 15/16

this will be changed in the next version of the manual.

PAGE 1
Preliminary manual / shortform for the VIBCONNECT RF 868/915MHz. For VIBCONNECT RF 2.4GHz necessary changes will be made. ----------------------------------------New text on page II : a) User Information gem. FCC 15.21 enthalten: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. b) Part 15 Statement gem. FCC 15.19/RSS Gen Issue 3 Sect. 7.1.
PAGE 2
Preliminary manual / shortform for the VIBCONNECT RF 868/915MHz. For VIBCONNECT RF 2.4GHz necessary changes will be made. ----------------------------------------Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.