User's Guide

ENR
Credential Enrollment Reader
Programming / Encoding Credentials
1. Go to the “User“ tab and plug the Proxess Enrollment Reader into the USB\
Power port of your phone or tablet. Click “OK”. Keep the credentials at least 6”
away.
2. The Card Mode is now “Info”. Click on the “Card Mode” tab and select
“Create”.
3. Select a User for the credential to be assigned to.
4. Place and leave the card on the reader for ~2-3 seconds, until it beeps.
Remove the card from the reader.
5. To confirm, Click on the “Card Mode” tab and select “Info”. Place the card on
the reader again. The credential record should now show the card that has
been assigned to the user.
6. To program more cards, change “Card Mode” back to “Create” and repeat
steps 1-3.
7. When finished, unplug the enrollment reader.
See the LoxIQ™ User Guide for more information
Programming / Encoding Credentials
1. The Pop-up Window
a. Go to any screen in the software.
b. Place a card on the enrollment reader.
c. The pop-up window presents several options for the operator.
d. The operator may click the “Pop out” button, which will undock this
window from the main ProxessIQ™ application. It may then be
dragged anywhere on the desktop, so that the user can continue
programming other screens in the ProxessIQ™ system. Once the pop
out window is open, remove the card from the reader.
2. Assigning a Credential to an Existing User
a. To assign the credential, click on the drop-down arrow. Select an
existing user\cardholder from the list and click on the “Assign New
Credential” button to complete the task.
i. NOTE: Users may have more than one credential. The user
selected may have only their information entered and this
may have been the first credential assigned to them, or
they may already have another credential.
b. Click “Save” and then “Ok”
c. Add “Access Profiles”, “Doors”, or “Door Groups” to complete that
user’s privileges.
d. Click “Save” and then “Ok”
e. Click “Write to Card” and quickly place the card on the reader. When
it beeps and flashes green, the privileges are on the card.
3. Adding a New User
a. With the card on the enrollment reader, click on the “Create New
User” button and the new user information screen will open.
b. Enter the First and Last name of the New User. Then, click “Save”.
c. Follow 2b-2e to write privileges to the New User’s credential.
See the ProxessIQ™ Software Manual for more information
Proxess LoxIQ™ User Guide
ProxessIQ™ Software Manual
proxess
.com