Front Panel Wiring Identification AMP 12PIN USB 8 AUX IN Power & Speaker Connection ZONE 1 1. POWER ON/OFF BUTTON REMOTE ZONE 2 MODE FUNCTION BUTTON NMEA LEN ZONE 3 2. PLAY/PAUSE BUTTON ANTENNA MUTE FUNCTION BUTTON 3. TRACK UP / TUNE UP / FAST FORWARD 4. TRACK DOWN / TUNE DOWN / REWIND 5. RETURN BUTTON 6. VOLUME INCREASE / DECREASE KNOB INSTALLATION BULLETIN To avoid possible water ingress into wire harness area, route the harness in the downward direction as shown below on the left.
Auxiliary Input Mode General Operation 1. To Select AUX mode Press RETURN button to display Home Menu, then turn VOL knob and press it to select AUX mode. (The foreground pop up icon refers to the source changing.) Or repeat press SRC button to select the desired mode. The use of auxiliary mode allows you to play the portable music device through the headphone jack. Note: An additional accessory/adaptor must be purchased in order for this to happen.
General Operation (SETUP) iPod/iPhone Operation 1. Master / Zone Volume Control Turn the knob clockwise or counter clockwise to adjust master volume level (0~45) in any playing status, each zone volume will change simultaneously. To adjust a Zone volume separately, press SEL knob at volume display status, turn VOL knob to select among ZONE1, ZONE2 and ZONE3, press SEL knob at desired zone and turn the knob again to adjust zone volume level.
General Operation (SETUP) USB Section Operation 5. FILE LIST (Folder / File Search) While USB is playing, press MENU button to show USB settings, press SEL knob to enter file list, it will display all the tracks in current playing folder. - To select other tracks in current folder, turn VOL knob and press it at desired track. - To select the track in other folders, press SEL button at the desired folder. 6.
General Operation (SETUP) USB Section Operation 2-3 Bluetooth Settings Press SEL knob at BLUETOOTH being highlighted BLUETOOTH SETTINGS to enter Bluetooth Settings. Turn VOL knob to AUTO CONNECT select sub-features, then turn VOL knob to adjust DEVICE NAME OFF the level of each sub-features. ON AUTO CONNECT: If you don’t want to auto connect to last paired phone, just set Auto Connect to OFF. It will default at ON. DEVICE NAME: R4500.
Bluetooth Section Operation Radio Section Operation 3. Pair BT Device In Bluetooth source, pick “R4500” option on your Bluetooth enabled device. (if you are prompted for a password, the code entered will be “0000 or 1234”.) Note: The Bluetooth pairing only happens with unit in Bluetooth mode. 1. To Select Radio mode Press RETURN button to display Home Screen, then turn VOL knob and press it to select AM, FM or WB mode. (The foreground popup icon refers to the source changing.
Radio Section Operation Bluetooth Section Operation 3. Auto Tuning In FM, AM, WB playing mode, press Tune up or down button to activate auto tune. This results in automatically stopping at next station of sufficient signal strength. 1. To Select Bluetooth mode Press RETURN button to display Home Menu, then turn VOL knob and press it to select Bluetooth mode. (The foreground pop up icon refers to the source changing.) Or repeat press SRC button to select the desired mode. 4.