FindersKeypers
Short Story I was in Las Vegas about four months ago meeting with several different performers and magic consultants, sort of the dream team in magic if you will. I showed prototypes of 5 different new product s that I currently have in development. I was looking for advise on which product to move forward with. The decision was unanimous. They all wanted FindersKeypers. They were not saying this is ‘the best’ of the five products. They really WANTED FindersKeypers.
ProMystic FindersKeypers Thank you for purchasing ProMystic’s FindersKeypers ‘FK’. You can now carry FK with you and be ready to perform at a moments notice.
ProMystic FindersKeypers The Receiver How to turn it on and off Slide the on/off switch. (See photo, below left.) When you switch the receiver on, it will vibrate for one second, letting you know it is activated. It does not vibrate when you switch it off. How to install batteries The receiver comes with two CR2032 batteries already installed. When the batteries are drained, the receiver will give one long, weak buzz, or just stop working.
ProMystic FindersKeypers Setting up your KeyFob The first step is to customize your keyfob by selecting a picture that will show through the window. This can be done by using the electronic transmitter and drawing a in pencil a light line around the outline. Make sure you center the picture you are using. Use pencil so you can erase if you need to. Next, cut along the pencil line, remove the sticker backing and stick to the flat part of the transmitter.
ProMystic FindersKeypers Open the Keyfob The FindersKeypers keyfob is made to look like a keychain/picture holder. This is specially designed to hide the gimmick right out in the open. It resembles a luggage tag that everyone is familiar with. Other designs yielded a poor looking keychain. This also enables the heads/tails routine as well. It is opened unscrewing the rivet on the bottom of the keyfob. This is designed so it can not be done by a spectator.
ProMystic FindersKeypers Installing the Battery and Setting Modes It is very easy to set the modes. This is done when you install the battery. Turn on the receiver and when you install the keyfob battery. When you install this battery you get a series of initial signals or buzzes.
ProMystic FindersKeypers Infinite Mode: Turn the receiver on to feel the signal and install the battery holding the transmitter with the flat circuit boar up and you will get a ‘2’ signal. In this mode the transmitter only turn off when exposed to a magnet or when ‘dialed’ off. This is useful when performing the Kurotsuke effect. When you put the key in the bag you need it to keep repeating unit someone takes it out of the special metallic material lined bag.
ProMystic FindersKeypers 10 Repeat Mode Turn the receiver on to feel the signal and install the battery while holding the transmitter with the battery side up and you will get a ‘3’ signal. In this mode the transmitter will give 10 repeats before going into silent mode. This can be used for performing which hand and the transmitter will shut off when held in the same orientation for 10 repeats. This is the default mode. The keyfob will turn off completely when exposed to a magnet.
ProMystic FindersKeypers Custom Mode Hold the transmitter with the battery long ways up and install the battery. This allows you to set the exact number of repeats you would like to perform with. Some people like several and some people like just a few repeats. This is personal preference. When you install the battery the transmitter will give ‘1’s while counting them.
ProMystic FindersKeypers How to Lock the Keyfob Magnetic – The Magnetic lock feature turn s the keyfob off and you do not need to keep the magnet on the item. The keyfob will remember its settings and the battery will last 1 year + in this mode. Hold a magnet to the corner of the keyfob opposite of the battery for a few seconds until it stops transmitting. Then remove from the magnet and the keyfob is off. Turn the keyfob back on by holding the keyfob back up to the magnet until you get a signal.
ProMystic FindersKeypers Performance Performance is very simple. They key and the keyfob are handed to the spectator. You should put all the fucus on the ‘other object’ like the key. When the hands are to the side you will get a ‘1’ signal. When the hand with the keyfob is raised you will either get a ‘2’ or a ‘3’ signal depending on what side on the keyfob is up. A ‘2’ is for heads or the picture is up and and a ‘3’ is for tails and the back of thekeyfob is up.
ProMystic FindersKeypers IMPORTANT WARRANTY Promystic products are warranted (i) against defects and workmanship and (ii) that when properly used , will execute their programmed instructions, for a period of 1 year from the date of product purchase. We will, at our option, repair or replace Promystic products that prove to be defective either upon your receipt or though normal usage.
Model: FK FCC ID: 2ARYL-FK This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation. CAUTION: Modification or changes to this equipment not expressly approved by the manufacturer may void the user’s authority to operate the equipment.