WATER LEAK DETECTOR USER MANUAL PROMISTEL INDUSTRIES www.promistel.
V1.0 Kimo Boissonnier 05/03/2021 Table des matières Presentation............................................................................................................................................. 1 Wireless communication system..............................................................................................................3 Data Format..............................................................................................................................................
V1.
V1.0 Kimo Boissonnier 05/03/2021 Wireless communication system Measurement data is sent using the 2.4 GHz mesh network of the Wirepas system. Collected data is sent automatically through the gateway according to your specifications. All the configuration is done remotely. Water Leak Detector Secured Payload Application Data Schematic Wirepas diagram The Custom Wirepas firmware designed by Promistel, PWS for Promistel Wirepas System, is supplied with all our sensors.
V1.0 Kimo Boissonnier 05/03/2021 Data Format The data sent by water leak detectors are from Source End Point 111 and with destination End Point according to the data type. The software is based on PWS, for a full list of PWS commands, please reference to the PWS documentation. Here is a short brief of the messages that the device will send. Descriptor (EP 0) This descriptor is a set of data describing the hardware and the configuration of the device. Param 1 (4 bytes) : the PWS version (A.B.C.
V1.0 Kimo Boissonnier 05/03/2021 Water Leak Terminal (EP 136) This value is for the pads in the casing Param 1 (signed int): The ADC value measured between the pads Water Leak Rope (EP 137) Param 1 (signed int): the ADC value measured within the structure of the rope Starting your product To start using your device, you only need to plug the Battery in the holder. Open the casing and push the battery in, like in the picture and close the casing again. Connect the Water Rope.
V1.0 Kimo Boissonnier 05/03/2021 Using the product Place the device with its electrodes on the ground where a water leak may occur, attach the water rope to cover additional area. Both will alert separately. Once an alert occurs, a notification also will be sent once to water rope is dry or that the Technical Specifications RADIO INTERFACE Frequency ISM (Non licensed) 2,4 GHz Wirepas Mesh Network (2.36 – 2.
V1.0 Kimo Boissonnier 05/03/2021 POWER SUPPLY Battery AA Lithium 2.4 Ah, 3.6 VDC CERTIFICATIONS Europe CE USA FCC HOUSING Dimensions 89.5mm x 83.5mm x 26mm Weight 40g Material PC/ABS ACCESSORIES Water leak rope Connection type: Jack plug Water leak rope length available: 0.2 – 1m Provided stainless steel contacts sensor (X2) Nominal diameter: 2.
V1.0 Kimo Boissonnier 05/03/2021 Legal Mentions FCC STATEMENT : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.