NOTICE_WS500_TLL 13/06/05 16:56 Page 140
NOTICE_WS500_TLL 13/06/05 16:56 Page 14 B3 C4 A1 C2 A4 B6 B7 A2 B5 A3 A6 A5 A7 We thank you for purchasing the Géonaute WS500 weather station. This device indicates the weather conditions for the next 12-24 hours by measuring trends in atmospheric pressure. It also lets you see at a glance the indoor temperature, the outdoor temperature (measured by GB a wireless sensor) and the time and date.
NOTICE_WS500_TLL 13/06/05 16:56 Page 16 FIRST USE / GETTIN' STARTED 4 - Carefully reinsert the seal of the sensor, taking care not to damage it. Next, close the sensor's battery cover with the 4 Phillips head screws. IMPORTANT! This paragraph is crucial to ensuring proper use of the device. It is very important to follow the instructions STEP by STEP when using the station for the first time. Do not skip any steps or do them out of order. The order of the steps is important.
NOTICE_WS500_TLL 13/06/05 16:56 Page 18 9 - Display channel 1 in the outdoor temperature field, by pressing repeatedly on the CHANNEL button. 12 - To enter setting mode, press on the MODE button for 3 seconds. Change the parameters with the arrows located on the back of the device and switch form one parameter to another by pressing on MODE (see relevant section). 10 - Press simultaneously on MIN/MAX and CHANNEL to initiate transmission. The symbol above number 1 starts flashing.
NOTICE_WS500_TLL 13/06/05 16:56 Page 20 Batteries Installing the batteries in the remote sensor and selecting the channel The remote sensor runs on two AAA (LR3) 1.5 V batteries. To install them and select the channel: 1. Unscrew the cover of the battery compartment. 2. Select the channel number using the CHANNEL switch. If you are simply changing the batteries, do not change the position of the CHANNEL switch.
NOTICE_WS500_TLL 13/06/05 16:56 Page 22 2 - Displays the temperatures 2 -1 Outdoor temperatures (remote sensors) This window displays the temperature in Celsius (°C) as measured by the wireless sensors transmitting data to the main unit. On the left side of the window, the number 1, 2 or 3 specifies the communication channel assigned to each remote sensor displayed (see the first use section, selecting the channel).
NOTICE_WS500_TLL 13/06/05 16:56 Page 24 SPECIFICATIONS Ð TROUBLESHOOTING TABLE Troubleshooting This troubleshooting table will guide you in solving minor incidents. Use it to analyze any problems you may encounter. Carry out the problem-solving procedures in numerical order. Incident Solution 1 The station is not displaying the temperature measured by the sensor. ---.- is displayed in the " outdoor temperature field " 1.