Installation Guide

SAFETY TIPS
Turn fixture off! (Place wall
switch in off position, if fixture
has built-in switch or chain pull,
switch or pull chain so fixture is
off.)
Next - go to the main fuse box.
If your fuse box has an ON/OFF
switch, simply place main power
switch in OFF position
Screw-in type fuses - unscrew
the fuse or fuses that control the
power to the fixture or room you
are working in.
READ IMPORTANT SAFETY TIPS BEFORE PROCEEDING WITH INSTALLATION
INSTALLATION INSTRUCTIONS
CONNECT THE WIRES. NOTE: Attach black fixture
wire to black supply wire, white fixture wire to
white supply wire. Do not mix them up. Use
approved electrical tape or wire connectors (not
provided). Connect bare fixture ground wire to
ground wire from outlet box. NEVER CONNECT
GROUND WIRE TO BLACK OR WHITE POWER
SUPPLY WIRES.
IS010
POSITION THE FIXTURE over the large cross bar
and secure in place with the thumb nuts (2 provid-
ed). Screw bulb into socket. Be sure to use bulb
with wattage no greater than specified for this fix-
ture.
ATTACH small cross bar to outlet box with outlet
box screws (8-32 x 1/2, screws not provided).
THREAD fixture mounting screws (8-32 x 1,2 pro-
vided) into large cross bar.
ATTACH large cross bar to small cross bar with
mounting screw (1/4 - 20 x 3/8,1 provided).
PLACE DIFFUSER ON FIXTURE BASE. Then place
bar grill on frame over diffuser and attach to base
with mounting screws (8-32 x 1/2, 4 combination
head screws provided). NOTE: Outdoor wall fix-
ture MUST be caulked with an acrylic caulk where
base of fixture meets mounting surface. This pro-
vides a water tight seal when fixture is installed.
3
2
1
4
thumb nuts
outer cross bar
fixture
mounting
screws
bar grill
diffuser
base
mounting screws
caulk
wire connectors
(not provided)
ground
wire
outlet
box
ground
wire
outlet box
screws
fixture
mounting
screws
mounting
screw
outer
cross bar
small
cross bar