User's Manual

ManualsBrandsProForm ManualsFitness & Gym EquipmentProform Carbon T10 Treadmill

SYMPTOM: The walking belt is not centered

between the foot rails

a. IMPORTANT: If the walking belt rubs against

the foot rails (D), the walking belt may become

damaged. First, remove the key and UNPLUG

THE POWER CORD. If the walking belt has

shifted to the left, use the hex key to turn the

left idler roller screw clockwise 1/2 of a turn; if the

walking belt has shifted to the right, turn the left

idler roller screw counterclockwise 1/2 of a turn. Be

careful not to overtighten the walking belt. Then,

plug in the power cord, insert the key, and walk on

the treadmill for a few minutes. Repeat until the

walking belt is centered.

SYMPTOM: The walking belt slips when walked on

a. First, remove the key and UNPLUG THE POWER

CORD. Using the hex key, turn both idler roller

screws clockwise, 1/4 of a turn. When the walk-

ing belt is correctly tightened, you should be able

to lift each edge of the walking belt 2 to 3 in. (5 to

7 cm) off the walking platform. Be careful to keep

the walking belt centered. Then, plug in the power

cord, insert the key, and walk on the treadmill for a

few minutes. Repeat until the walking belt is prop-

erly tightened.

SYMPTOM: The displays of the console do not

function properly

a. If the console does not boot up properly, or

if the console freezes and does not respond,

reset the console to the factory default settings.

IMPORTANT: Doing this will erase all the

custom settings you have made to the console.

Resetting the console requires two people. First,

press the power switch into the off position. Next,

locate the small reset opening (D) on the right side

of the console. Using a bent paper clip (E), press

and hold the reset button inside the opening, and

have a second person press the power switch into

the on (reset) position. Continue holding the reset

button (D) until the console turns on. When the

reset operation is complete, the console will turn off

and then turn back on. If it does not, use the power

switch to turn the treadmill off and then on again.

Once the console turns on, check for firmware

updates (see step 5 on page 24). Note: It may take

a few minutes for the console to be ready for use.

SYMPTOM: The treadmill will not connect to the

wireless network

a. Make sure that the wireless settings on the console

are correct (see page 25).

b. Make sure that the settings for your wireless net-

work are correct.

c. If you still have questions, go to support.iFit.com.