User's Manual

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted.

To adjust the reed switch, first unplug the power

adapter. Next, locate the Reed Switch (57) on the

left side of the exercise bike. Slightly loosen the two

M4 x 20mm Screws (87).

Next, turn the Left Crank Arm (19) until a Magnet (62)

is aligned with the Reed Switch (57). Slide the Reed

Switch slightly toward or away from the Magnet. Then,

retighten the M4 x 20mm Screws (87).

Plug in the power adapter and turn the Left Crank Arm

(19) for a moment. Repeat the procedure above, if nec-

essary, until the console displays correct feedback.

When the Reed Switch (57) is correctly adjusted, plug

in the power adapter.

HOW TO ADJUST THE DRIVE BELT

If you feel the pedals slip while you are pedaling, even

when the resistance is adjusted to the highest level,

the drive belt may need to be adjusted.

To adjust the drive belt, first unplug the power

adapter. Next, locate the Idler Cover (36). Remove the

M4 x 12mm Screw (80) and the Idler Cover.

Then, tighten the M10 x 60mm Screw (65) until the

Drive Belt (not shown) is tight.

When the Drive Belt (not shown) is tight, reattach the

Idler Cover (36) and plug in the power adapter.