Instructions / Assembly

MAINTENANCE

Regular maintenance is important for optimal per-

formance and to reduce wear. Inspect and properly

tighten all parts each time the elliptical is used.

Replace any worn parts immediately.

To clean the elliptical, use a damp cloth and a small

amount of mild dish soap. IMPORTANT: Keep liquids

away from the console and keep the console out of

direct sunlight. During storage, remove the batter-

ies from the console.

CONSOLE TROUBLESHOOTING

Most console problems are the result of low batteries.

To replace the batteries, see assembly 7 on

page 10.

If the handgrip heart rate monitor does not function

properly, see step 5 on page 20.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted.

Using a standard

screwdriver, remove

the Top Shield (41).

Note: For clarity, the right pedal disc is not shown in the

drawing below.

Locate the Reed Switch (53). Loosen, but do not

remove, the M4 x 16mm Screw (52).

Next, rotate the Pulley (61) until a Magnet (58) is

aligned with the Reed Switch (53). Slide the Reed

Switch slightly toward or away from the Magnet. Then,

retighten the M4 x 16mm Screw (52). Rotate the Pulley

for a moment.

Repeat these actions until the console displays correct

feedback.

When the reed switch is correctly adjusted, reattach

the top shield.

MAINTENANCE AND TROUBLESHOOTING