Owners manual

ManualsBrandsProForm ManualsCardio EquipmentCardio Hiit Trainer Pro

MAINTENANCE

Regular maintenance is important for optimal

performance and to reduce wear. Inspect and properly

tighten all parts each time the trainer is used. Replace

any worn parts immediately.

To clean the trainer, use a damp cloth and a small

amount of mild soap. IMPORTANT: To avoid damage

to the console, keep liquids away from the console

and keep the console out of direct sunlight.

CONSOLE TROUBLESHOOTING

If the console does not turn on, make sure that the

power cord is fully plugged in and that the power

switch is in the reset position.

If you are having problems connecting the console

to a wireless network or if you are having problems

with your iFit account or iFit workouts, go to

support.iFit.com.

If the console does not display your heart rate when

you hold the handgrip heart rate monitor, or if the dis-

played heart rate appears to be too high or too low, see

step 5 on page 21.

If the console does not display your heart rate

when you use the chest heart rate monitor, see

TROUBLESHOOTING on page 14.

TABLET HOLDER TROUBLESHOOTING

If the tablet holder does

not stay in place, rotate

the tablet holder backward

and tighten the screw (A)

until the tablet holder stays

in place when it is rotated

to the desired position.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted. To adjust the reed

switch, first unplug the power adapter.

Next, remove the

four indicated

M4 x 16mm Flat

Head Screws

(101), and then

remove the

Lower Rear

Shield Cover

(68).

Next, turn the Large Pulley (21) until a Pulley Magnet

(121) is aligned with the Reed Switch (116). Then,

slightly loosen the M4 x 19mm Screw (113), slide the

Reed Switch slightly closer to or away from the Pulley

Magnet, and retighten the Screw.

Then, plug in the power adapter and turn the Large

Pulley (21) for a moment. Repeat these actions, if

necessary, until the console displays correct feedback.

Then, reattach the lower rear shield cover.

101

113

116

121

MAINTENANCE AND TROUBLESHOOTING