Manual

ManualsBrandsProform ManualsFitness & ExerciseOfficial Proform cross trainer

TROUBLE-SHOOTING AND MAINTENANCE

Inspectand tighlenall partseach timeyou usethe CROSS TRAINERe. Replace any warn parts immediately. Outside

surfacesof theCROSSTRAINERe can be cleaned usinga damp clothand mild detergent. Keep all liquids away from

thestepperconsoleand the PERSONALTRAINER computer. Most CROSSTRAINER• problems can be solvedby follow-

ing theslapsbelow. Findthe applicable symptomand fallow the slap(s)lided. If furtherassistanceis needed, call our

CustomerServiceDepadmenttoll-free at 1-800-999-3756, Monday throughFriday, 6 a.m. until'6 p.m. Mountain

.time (excludingholidays).

1. SYMPTOM: THE PERSONALTRAINER COMPUTER DISPLAYSAN ERROR CODE ("EEE")

a. While theweightsettingischanging, the motorwillbeheardandtheSETSandREPSdisplayswillshowa rapidly

rotatingindicator.To preventdamage to the weight system,do notputany pressureon the leg developer,arms

or cableswhilethe weight settingischanging. Ifthe tat bar or rower bar isattachedto the high pulleystation,restit

in therock near thehigh pulleystation.Wait for.the soundof themotorto stopbeforeyou continue. If the comput-

er sensespressure on theweight systemwhile theweight settingischanging, the WEIGHT display will showan

• error code ("EEE")for two seconds,and the weight settingwill sl-opchanging. TheWEIGHT dis'pla),will then show

the current weight setting.Make surethat there is no pressureon theleg developer, arms or cables. Pressthe

increaseor decrease button beneath the WEIGHT display to changethe weight settingas desired.

2. SYMPTOM: THE MAIN CABLEDOES NOT MOVE SMOOTHLY, OR THERE IS SLACK IN THE MAIN CABLE

a. Inspectthe routingofthecables and make surethat they are in the groovesin all of the pulleys.If they are not,

tarred the problem. If thecables are not properly routed, they will be damaged when used..

b. If there isslackin the Main Cable (51), locate the

AdjustmentBracket(53) near the bottom of the

.... right side shield.Hold the end of theWeight Cable

(52) firmly, and slidethe AdjustmentBracketfar-

ther ontothe Weight Cable. Tightenthe 5/16" Nut

(82) ogaiestthe AdjustmentBracket.Testthe Main

Cable. If the mator stallsor hesitates,loosenthe

5/16" Nut slightly.If the 5/16" Nut is tightened as

far as passible and thereisstill slack,the Main

Cable shouldbe replaced.See ORDERING

REPLACEMENTPARTSon the back cover of this

ownerls monuok

3.- SYMPTOM:THE STEPPERCONSOLE DOES NOT

FUNCTION PROPERLY

a, As you step,movethe stepper pedals verticallyat

least8 inches.If)our stepsare too shallow, the

movementof the stepperpedals will not be detect-

ed. If the stepperconsolestilldoes not function

properly, theReedSwitch(99) con be adjusted by

slidingthebarrel of the ReedSwitch up and down

slightly.Repeatuntilthe stepperconsoledisplays

correctfeedback.If necessary,the 3/4" Screw

(119} attachingthe ReedSwitchBracket(120) can

be loosenedand the positionof the Bracketcan be

adjusted.

120

I 119/

_ounting

eeye