Manual

14. Attach the Seat (28) to the Upright (9} with the two

1/4" x 3/4" Bolts (20) and a 1/4" x 2 1/2" Bolt

(46).

15. Center one Pad Tube (22) in the Upright (9), and the

other Pad Tube in the Leg Developer (23). Slide the

four Small Pods (17) onto the ends of the Pad Tubes.

16. Rest the Leftand Right Pedals (75, 76) on the hooks

at the lower ends of the Resistance Cylinders (84).

Make sure that the hooks are fully inserted into the

same slotsunder both Pedals.

Plug the TransFormer (39) intothe jack located near

the bottom of the Right Side Shield (12).

17. Make surethat oil ports are properly tightened. The use of oil remaining PoX will be explained in ADJUSTING

THE CROSSTRAINER e, beginning on page 8 oFthis owner's manual.

18. Before using the CROSS TRAINER e, test the cables and thepulleys. Make sure that the cables are in the grooves

in the pulleys. If the cables do not move smoothlyover the pulleys, locate and correct the problem before using

the CROSSTRAINER e. If the'€':ablesare not properly routed, they will be damaged when used.