Manual

18. Press a Top Bracket Bushing (55) into the Top
Bracket (36). Using a rubber mallet, tap the Top
Bracket onto the Left Upright (31) and the Guide
Bar (32).
Attach the Top Bracket (36) to the Left Updght
(31) with two M10 x 65mm Button Bolts(60), four
M10 Washers (67), and two M10 Nylon Locknuts
(69). Do not tighten the Locknuts yet.
Attach the Top Bracket (36) to the Guide Bar (32)
with an Mt0 x 30ram Button Screw (56) and an
M10 Washer (67).
Assemble the other Top Bracket (36) in the
same manner.
19. Slide the Weight Bar (33) throughthe Left Barbell
Glider (37), the Locking Bar (34), and the Right
Barbell Glider (81). Make sure the Locking Bar
is oriented as shown.
Engage the hooks on the Locking Bar (34) into a
set of holes in the Uprights (31, 62).
20. Slide a Weight Stop (42) onto the Weight Bar
(33). Thread a 1/4" x 14ram Button Screw (59)
into the Weight Stop and the hole in the Weight
Bar. Do not tighten the Screws yet.
Thread a 1/4" x 14mm Button Screw (59) into the
Left Barbell Glider (37),
Repeat this step with the Right Barbell Glider
(not shown) and the other Weight Stop (not
shown).
21. Press a 48ram Tapered Inner Cap (46) into a
Barbell Adapter (41).
Slide a Barbell Adapter (41) onto the Weight Bar
(33). Thread a 1/4" x 9.5mm Allen Head Set
Screw (66) into the Barbell Adapter. Do not tight-
en the Screw yet.
Repeat this step with the other Barbell
Adapter (not shown).
Tighten the M10 Nylon Locknuts (69) used in
steps 11-2t. Tighten the 1/4" x 14mm Button
Screws (59) and 114"x 9.5mm Allen Head Set
Screw (66) used in steps 20 and 21,
18
19
20
21
q
81 _
56-
i
67--*_._ 36
67 "
H-/-31
31
33
.42
33
41
46
11