User`s manual

ManualsBrandsProForm ManualsHome Gym660 Weight Bench

Locate the Reed Switch (63) and the Magnet (46) on

the left side of the Pulley (47). Turn the Pulley until

he Magnet is aligned with the Reed Switch. M

ake

sure that the gap between the Magnet and the

eed Switch is about 1/8 in. (3 mm).

f necessary,

loosen the Tie Screw (7), move the Reed Switch

slightly, and then retighten the Screw. Reattach the

Hood (not shown), and run the treadmill for a few min-

utes to check for a correct speed reading.

PROBLEM: The console displays remain lit when you remove the key from the console

SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a

store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off

the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE

INFORMATION MODE on page 16 to turn off the demo mode.

PROBLEM: The walking belt slows when walked on

SOLUTION:

a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 9.

b. If the walking belt is overtightened, treadmill perfor-

mance may decrease and the walking belt may be-

come damaged. Remove the key and UNPLUG THE

POWER CORD. Using the hex key, turn both rear

roller bolts counterclockwise, 1/4 of a turn. When the

walking belt is properly tightened, you should be able

to lift each edge of the walking belt 2 to 3 in. (5 to 8

cm) off the walking platform. Be careful to keep the

walking belt centered. Then, plug in the power cord,

insert the key, and run the treadmill for a few minutes.

Repeat until the walking belt is properly tightened.

c. If the walking belt still slows when walked on, please see the front cover of this manual.

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt is off-center, first remove the key

and UNPLUG THE POWER CORD. If the walking

belt has shifted to the left,

use the hex key to turn

the left rear roller bolt clockwise 1/2 of

a turn;

if the

walking belt has shifted to the right, turn the

bolt

counterclockwise 1/2 of a turn. Be careful not to over-

tighten the walking belt. Then, plug in the power cord,

insert the key, and run the treadmill for a few

minutes.

Repeat until the walking belt is centered.

If the walking belt slips when walked on, first re

move the key and UNPLUG THE POWER CORD.

Using the hex key, turn both rear roller bolts clock-

wise, 1/4 of a turn. When the walking belt is correctly

tightened, you should be able to lift each side of the

walking belt 2 to 3 in. (5 to 8 cm) off the walking plat-

form. Be careful to keep the walking belt centered.

Then, plug in the power cord, insert the key, and care

fully walk on the treadmill for a few minutes. Repeat

until the walking belt is properly tightened.

Rear Roller Bolts

2–3 in.

Top

View

/8 in.