User`s manual

3. Press the two Base Endcaps (99) (only one is shown)
into the Base (109). Make sure that the angle of each
Base Endcap matches the angle of the Base, as shown
in the inset drawing.
Insert a Wheel Housing (106) into the Base (109). Make
sure that the Wheel Bolt (107) is on the side shown. Insert
the other Wheel Housing (not shown) in the same way.
Attach the four Base Pads (100) (only two are shown) to
the bottom of the Base (109) with eight 3/4” Tek Screws
(47). Note: There are no screw holes in the Base
Endcaps (99). Press firmly on the screwdriver when tight-
ening the Tek Screws.
With the help of a second person, carefully tip the tread-
mill so the four Base Pads (100) are resting on the floor.
3
100
109
47
99
100
21
47
4. Identify the left handrail, which has a hole in the indicated
location, and the right handrail. Hold the right handrail
near the Right Upright (82). Insert the Wire Harness (83)
into the large hole in the right handrail and out of the
upper end as shown.
Next, hold the right handrail against the Right Upright (82),
and hand tighten two 5/16” x 1” Bolts (122) into the upper
end of the right handrail and the Right Upright. Be care-
ful not to drop the Bolts into the handrail. Tighten a 4”
Bolt (112) into the Right Upright and the lower end of the
right handrail. Firmly tighten all three Bolts.
Attach the left handrail to the Left Upright (81)as de-
scribed above. Note: There is not a wire harness in the
Left Upright.
Press two Upright Endcaps (69) into the upper ends of
the Uprights (81, 82). Make sure that the notches in the
Upright Endcaps are up as shown.
4
82
81
83
Notch
Notch
69
69
122
122
Left
Handrail
Right
Handrail
Hole
112
112
99
109
2. Attach a Wheel (108) to each Wheel Housing (106) with
a Wheel Bolt (107) and Wheel Nut (21). Make sure that
the Wheel Bolts are inserted from the sides shown.
Do not overtighten the Wheel Bolts.
2
107
106
106
21
107
108
7
106
107