User`s manual

9
7. Route the Upright Wire (28) through one of the
Handrails (18) as shown, and remove the wire tie
f
rom the Upright Wire.
A
ttach the Handrail (18) to the Right Upright (36)
with two 5/16" X 2 1/4" Bolts (20) and two 5/16"
Star Washers (19). Be careful not to pinch the
Upright Wire (28).
Attach the other Handrail (18) to the Left Upright
(31) with two 5/16" X 2 1/4" Bolts (20) and two
5/16" Star Washers (19).
31
2
8
W
ire Tie
20
19
18
2
0
1
9
18
7
28
18
8. While another person holds the Console Base
(26) near the right Handrail (18), attach the
ground wire on the Console Base to the right
Handrail with a 1/2" Ground Screw (11).
Connect the wire harness on the Console Base
(26) to the Upright Wire (28).
See the inset
drawing. The connectors should slide to-
gether easily and snap into place. If they do
not, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED PROP-
ERLY, THE CONSOLE MAY BE DAMAGED
WHEN THE POWER IS TURNED ON.
11
26
Ground
Wire
28
Wire
Harness
8
22
9. Insert the wires into the Console Base (26) as
you set the Console Base on the Handrails (18).
Be careful not to pinch the wires. Next, thread
two 1/4" X 1/2" Bolts (22) with 1/4" Star Washers
(21) into the Handrails and the Console Base; do
not tighten the Bolts yet.
Attach the Console Base (26) to the Handrails
(18) with four 3/4" Screws (2). Then, tighten the
two 1/4" X 1/2" Bolts (22).
2
22
21
21
2
18
18
9
26
Front View
36