User`s manual

7
3.
Attach a Wheel (45) to each side of the Base
(48) with a 3/8" x 2 1/4" Bolt (40), two Wheel
Spacers (44), and a 3/8" Nut (47) as shown.
Do
not overtighten the Bolts; the Wheels should
turn freely.
48
45
47
44
44
40
45
44
44
40
47
3
2
. Orient the Left Upright (31) as shown, and attach
it to the Base (48) with two 3/8" x 2 1/4" Bolts
(
40) and two 3/8" Star Washers (39);
d
o not
tighten the Bolts yet.
48
31
39
39
40
Latch
Holes
2
4. Raise the Uprights (31, 36) so that the Base (48)
is flat on the floor and positioned as shown.
See the far right drawing. Wrap the wire tie in
the Right Upright (36) around the end of the
Upright Wire (28). Then, pull the other end of the
wire tie until the Wire Harness is extending from
the upper end of the Right Upright.
Make sure that the end of the Upright Wire
(28) does not fall into the Right Upright (36).
4
28
Wire Tie
48
28
36
31
Large
Hole
Wire
Tie