User`s manual

20
9
7. Identify the Right Handrail Endcap (91), which
does not have a cutout in the bottom, and slide it
onto the lower end of the Right Handrail (11).
Make sure that the screw hole in the Right
Handrail Endcap is at the bottom. Next, hold the
Right Handrail near the Right Upright (36), and
insert the Upright Wire (28) into the hole in the
bottom of the Right Handrail and out of the indi-
cated hole in the top. Then, remove the tie from
the Upright Wire.
Set the Right Handrail (11) on the Right Upright
(36) while sliding the lower end of the Right
Handrail onto the bracket on the Right Upright.
Hand tighten two Handrail Bolts (20) with two
Handrail Star Washers (19) into the Right
Handrail and the Right Upright. Next, slide the
Right Handrail Endcap (91) against the Right
Upright, and tighten an Endcap Screw (95) into
the Right Handrail Endcap. Then, tighten the two
Handrail Bolts. Make sure that the Upright
Wire (28) is not pinched.
Attach the Left Handrail (18) and the Left
Handrail Endcap (90) to the Left Upright (31) as
described above.
36
31
95
95
91
90
Cutout
28
20
19
18
19
20
11
7
HOW TO CONNECT YOUR HOME STEREO
N
ote: If your stereo has an unused LINE OUT jack,
see instruction A below. If the LINE OUT jack is
b
eing used, see instruction B.
A. Plug one end of a long 3.5mm to RCA stereo audio
cable (available at electronics stores) into the input
jack on the console. Plug the other end of the cable
into the LINE OUT jack on your stereo. Note: While
the cable is plugged into the LINE OUT jack, do not
plug your headphones into the headphone jack on
the console.
B. Plug one end of a long 3.5mm to RCA stereo audio
cable (available at electronics stores) into the input
jack on the console. Plug the other end of the cable
into an RCA Y-adaptor (available at electronics
stores). Next, remove the wire that is currently
plugged into the LINE OUT jack on your stereo and
plug the wire into the unused side of the Y-adaptor.
Plug the Y-adaptor into the LINE OUT jack on your
stereo. Note: While the Y-adaptor is plugged into the
LINE OUT jack, do not plug your headphones into
the headphone jack on the console.
HOW TO CONNECT YOUR COMPUTER
A
. Plug one end of a long 3.5mm to 3.5mm stereo
audio cable (available at electronics stores) into the
i
nput jack on the console. Plug the other end of the
cable into the LINE OUT jack on your computer.
Note: While the cable is plugged into the LINE OUT
jack, do not plug your headphones into the head-
phone jack on the console.
A
L
INE OUT
Audio Cable
A
B
A
CD
VCR
Amp
LINE OUT
LINE OUT
CD
VCR
Amp
LINE OUT
Audio Cable
A
B
A
CD
VCR
Amp
LINE OUT
LINE OUT
CD
VCR
Amp
L
INE OUT
Audio
Cable
RCA
Y-adaptor
Wire removed from
LINE OUT jack
B
6. Pull the indicated wire until the Upright Wire (28)
is extending from the upper end of the Right
U
pright (36). Then, disconnect and discard the
wire.
Remove the elastic bands from the Left and
Right Base Leg Covers (101, 102) and press
them onto the Base (48) as shown.
36
102
48
101
6
28
Wire