User`s manual

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted.

To adjust the reed switch, you must remove the right

disc cover and the right pedal disc.

Using a flat screwdriver, remove the right Disc Cover

(18).

Next, remove the M8 x 12mm Screws (81) from the

Right Pedal Disc (27),

Then, see EXPLODED DRAWING A on page 26 and

remove the Pedal Arm Cap (30), the M8 x 18mm Hex

Screw (85), and the M8 Washer (33) from the Right

Pedal Arm (49).

Locate the Reed Switch (58). Loosen, but do not

emove, the M4 x 16mm Screw (92).

Next, rotate the Crank Assembly (24) until a Magnet

(41) is aligned with the Reed Switch (58). Slide the

Reed Switch slightly toward or away from the Magnet.

Then, retighten the M4 x 16mm Screw (92).

Rotate the Crank Assembly (24) for a moment. Repeat

these actions until the console displays correct feed-

back.

When the reed switch is correctly adjusted, reattach

the right pedal disc and the right disc cover.