User`s manual

2, With the heUpof another person, carefully Uowerthe

Uprights (69) as shown, Note: Utmay be heUpfuUto pUace

one foot on one of the Extension Legs (63) as you tip the

Uprights, Make sure that the Extension Legs remain

in the Uprights.

Attach each Extension Leg (63) with two 1" Tek Screws

(39) and a Round Base Pad (57) as shown, Attach the

tower Tek Screw, without the Round Base Pad, first.

Attach two more Round Base Pads (57) to the base of

the Uprights (69) with two 1" Tek Screws (39), Note: One

repUacement Round Base Pad may be included, ff a

Round Base Pad becomes worn and needs to be re-

pUaced, use the repUacement Round Base Pad,

Attach the two WheeUs (66) with two 2" BoUts(64) and

two WheeUNuts (32) as shown, Do not overtighten the

BoJts; the WheeUs shouUd be aMe to spin freeUy,

With the heUpof another person, carefully raise the

Uprights (69) to the verticaUposition,

3. With the heUpof a second person, tip the treadmHUso the

Base (not shown) is fiat on the floor.

hsert the tab on one of the Handrail Brackets (40) into the

suet in the right Upright (69), Attach the Handrail Bracket

with a 3/4" Screw (2), Attach the other Handrail Bracket to

the left Upright (not shown) as described above,

69 66 64

4, Identify the Right Handrail (72), which has a large hole in

the left side, Feed the Upright Wire (42) into the hole in

the bottom of the Right Handrail and out of the large hole

in the side, Note: It may be helpful to use needlenose pli-

ers to pull the Wire Harness out of the hole,

Press a Handrail Cap (16) onto the lower end of the

Right Handrail (5) as shown,

Set the Right Handrail (72) on the right Upright (69), with

the the lower end inserted into the Handrail Bracket (40),

Attach the Right Handrail (72) with an Upright Bolt (37) in

the upper end and a 3/4" Screw (2) in the lower end,

Attach the Left Handrail (71) as described above, Note:

There is not a wire harness on the left side,

Hole