User`s manual

Inspect and tighten all parts of the exercise bike regu-

larly. Replace any worn parts immediately.

To clean the exercise bike, use a damp cloth and a

small amount of mild soap. IMPORTANT: To avoid

damage to the console, keep liquids away from

the console and keep the console out of direct

sunlight.

CONSOLE TROUBLESHOOTING

Most console problems are the result of low batter-

ies. See assembly step 10 on page 10 for battery

replacement instructions.

If the console does not display your heart rate when

you use the handgrip heart rate monitor, see step 5 on

page 15.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted.

To adjust the reed switch, you must remove the seat

post, the post knob, and the top shield (see the instruc-

tions below).

To remove the Seat Post (5), loosen the Post Knob (11)

a few turns, pull the Post Knob outward, and remove

the Seat Post. Then, using an adjustable wrench,

remove the Post Knob.

Using a flat screwdriver, release the tabs along the bot-

tom edge of the Top Shield (9) and slide the Top Shield

upward.

Locate the Reed Switch (21). Turn the Pulley (13) until

a Pulley Magnet (16) is aligned with the Reed Switch.

Loosen, but do not remove, the indicated M4 x 16mm

Screw (40). Slide the Reed Switch slightly closer to or

away from the Magnet, and then retighten the Screw.

Turn the Pulley (13) for a moment. If necessary, repeat

the step above until the console displays correct

feedback.

When the reed switch is correctly adjusted, reattach

the shield cover, the post knob, and the seat post.

MAINTENANCE AND TROUBLESHOOTING