User`s manual

16. Make sure that all parts of the elliptical are properly tightened. Note: Some hardware may be left over

after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical.

14. Apply a small amount of grease to the axle on

the Right Crank Arm (16) and to a Large Wave

Washer (76).

Slide the Large Wave Washer (76) and the Right

Pedal Arm (12) onto the axle on the Right Crank

Arm (16).

Slide an M10 Washer (35) onto an M10 x 25mm

Screw (40), and tighten the Screw into the axle.

Then, press a Pedal Arm Cap (74) into the Right

Pedal Arm (12).

Repeat this step on the other side of the

elliptical.

15. Apply a small amount of grease to an M6 Bolt

Set (25).

Hold the end of the Right Pedal Arm (12) inside

the bracket on the right Upper Body Leg (5).

Attach the right Upper Body Leg (5) to the Right

Pedal Arm (12) with the M6 Bolt Set (25). Do

not overtighten the Bolt Set; the right Upper

Body Leg must pivot freely.

Repeat this step on the other side of the

elliptical.

See step 3. Tighten the M10 x 73mm Bolts (7)

and press the Top Shield (41) into place.

Grease