User's Manual

14. Insert the M10 x 20mm Bolt (66) into the Weight

Carriage (62) from the side shown.

Slide the Weight Carriage (62) onto the Rear

Upright (33) as shown.

13. Identify the Right Weight Rest (53) and Right

Spotter (9) by the location of the indicated holes.

Attach a Weight Rest Pin (24) to the Right Spotter

(9) with an M4 x 25mm Self-tapping Screw (42).

Slide the Right Spotter onto the Right Upright (55)

and engage the Weight Rest Pin into the Spotter

and Upright.

Attach a Weight Rest Pin (24) and the Right

Weight Rest (53) to the Right Upright (55) in the

same manner.

Repeat this step with the Left Upright (not

shown).

12. Attach the Right Base (47) to the Left Base (46)

with two M8 x 69mm Bolts (58), two M8 Washers

(

37), and two M8 Nylon Locknuts (41). M

ake

sure that the bolts heads are inside the hexag-

nal holes in the Left Base. Do not tighten the

Locknuts.

Hole